28-31-15
 ALL  ú ú 04 Page 403 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 FUEL JETTISON CONTROL CARD - ADJUSTMENT/TEST
____________________________________________
 1.  General_______
 A.  This procedure contains an operational test of the fuel jettison control cards (FJCC), FJCC A and FJCC B. To do a test on the FJCCs with a power up BITE you must open the circuit breakers or ground the FJCCs at the M7852 fuel system card file. If the circuit breakers are opened, you must stop for 5 minutes to start the test.
 B.  The FJCC BITE does a test on the random access memory (RAM), read only memory (ROM), processor, outputs in the OFF mode and outputs in the ON mode. The outputs in the ON mode are examined by the start of the logic necessary to cause the output to turn on. The outputs are started for less than 1.5 milliseconds so as not to operate the relays that control the jettison valves.
 C.  The CMC message 28665 FUEL JETTISON CONTROL CARD A FAIL or 28666 FUEL JETTISON CONTROL CARD B FAIL will show if a FJCC fails the power up BITE test. These EICAS messages can show in with the above CMC messages:
 (1)
FUEL JETT A (STATUS)

 (2)
FUEL JETT A (ADVISORY)

 (3)
FUEL JETT B (STATUS)

 (4)
FUEL JETT B (ADVISORY)

 (5)
FUEL JETT SYS (CAUTION)

 TASK 28-31-15-705-001
 2.  Fuel Jettison Control Cards (FJCCs) Operational Test____________________________________________________
 A.  References
 (1)
AMM 24-22-00/201, Manual Control

 (2)
AMM 28-22-16/401, Fuel System Card File

 (3)
AMM 31-61-00/501, Intergrated Display System (IDS)

 (4)
AMM 32-09-02/201, Air/Ground Relays

 (5)
AMM 34-61-02/401, Control Display Unit

 (6)
AMM 45-10-00/201, Control Maintenance Computer System

 (7)
AMM 45-10-00/501, Control Maintenance Computer System

 B.  
Access

 (1)  
Location Zones 115 Area Between Nose Gear Well and Fuselage, Left 221 Control Cabin, Left 222 Control Cabin, Right

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-31-15
 ALL  ú ú 01 Page 501 ú Feb 15/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 C.  Preconditions
 S 865-020
 (1)  
These conditions are necessary for this task:

 (a)  
Fuel Jettison System serviceable.

 (b)  
A specific fuel quantity is not necessary for this task.

 (c)  
Electrical Power On (AMM 24-22-00/201).

 (d)  
Fuel System Card File serviceable (AMM 28-22-16/401).

 (e)  
Integrated Display System (IDS) serviceable (AMM 31-61-00/501).

 (f)  
Airplane must be in ground mode (AMM 32-09-02/201).

 (g)  
CDU installed (AMM 34-61-02/401).

 (h)  
Central Maintenance Computer (CMC) serviceable (AMM 45-10-00/501).

 D.  
Prepare for Test

 S 865-002
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 865-019

 (2)  
Make sure the airplane is in ground mode (AMM 32-09-02/201).

 S 865-003

 (3)  
Close these circuit breakers:

 (a)  
P6 Main Power Distribution Panel
 1) 6C17, FUEL JTSN CONT B
 2) 6D17, FUEL JTSN CONT A
 3) 6E17, CTR R & MAIN 2 JTSN VLV
 4) 6F17, CTR L & MAIN 3 JTSN VLV

 (b)  
P180 DC Power Distribution Panel
 1) 180H17, FUEL SYS EICAS INTFC CONT

 E.  
Procedure

 S 745-013
 (1)  
Use one of these two procedures to start the fuel jettison control card (FJCC) A and B BITE:

 (a)  
Open these circuit breakers:

 1)  P6 Main Power Distribution Panel a) 6C17, FUEL JTSN CONT B b) 6D17, FUEL JTSN CONT A

 (b)  
After 5 minutes, close these circuit breakers:

 NOTE: When you close the circuit breakers after the
____ power stops for 5 minutes, the fuel jettison control card (FJCC) A and B BITE test starts.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護(hù)手冊 燃油 FUEL 4(77)