(f)  
Push the + switch until Diagnostic shows.

 (g)  
Push the SET switch.

 (h)  
Push the + switch until Flash ID shows.

 (i)  
Push the SET switch.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-35-02
 ALL  ú ú 06 Page 202 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (j)  
Make sure that the flash status is OK.

 (k)  
Push the SET switch again to start the flash erase procedure.

 (l)  
After several minutes, make sure that Pass (Reset) shows.

 (m)  
After the QAR does a reset procedure, make sure that OQAR Ready shows.

 TASK 31-35-02-732-088
 3. Disk Replacement for the Optical Quick Access Recorder (QAR)
____________________________________________________________
 A. General
 (1)  This procedure contains:
 (a)  
A removal of the optical disk from the quick access recorder (QAR).

 (b)  
A installation of the optical disk in the QAR.

 B. Disk Removal
 S 862-089
 (1)  Make sure this circuit breaker is closed:
 (a)  On the P145 panel
 1) 415L38 ACMS AC

 S 012-100
 (2) Do these steps to remove the optical disk from the Teledyne OQAR:
 (a)  
Open the door of the QAR.

 (b)  
Push the EJECT switch on the QAR.

 NOTE: The display on the QAR shows Ejecting and then
____
 Insert Disk.

 (c)  
Remove the disk and put it in a protective container.

 (d)  
Close the QAR door.

 C. Disk Installation
 S 862-083
 (1)  Make sure that this circuit breaker is closed:
 (a)  On the P145 panel.
 1) 415L38 ACMS AC

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-35-02
 ALL  ú ú 13 Page 203 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 412-103
 (2) Do these steps to install the optical disk into the Teledyne OQAR:
 (a)
Open the door of the QAR.

 (b)
Push the disk into the QAR.

 (c)
Make sure the display on the QAR shows OQAR Ready.

 (d)
Close the door of the QAR.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-35-02
 ALL  ú ú 10 Page 204 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 QUICK ACCESS RECORDER - REMOVAL/INSTALLATION
____________________________________________
 1.  General_______
 A.  The two tasks in this procedure are the removal and the installation of the Quick Access Recorder (QAR). The installation task includes an operational test of the QAR.
 B.  The QAR is installed on the E1-5 shelf in the main equipment center.
 TASK 31-35-02-004-001
 2.  Quick Access Recorder Removal_____________________________
 A.  References
 (1) AMM 20-11-22/401, Rack-Mounted Electrical/Electronic Module
 B.  Access
 (1)  
Location Zone
 117 Electrical/Electronic Compartment, LH

 (2)  
Access Panel
 117AL E/E Bay Access Door

 C.  Procedure
 S 864-002
 (1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
 (a)  P415, Power Distribution Center
 1) 415L38, ACMS AC

 S 024-061
 CAUTION: DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS ON THE
_______ QUICK ACCESS RECORDER. IF YOU TOUCH THESE CONDUCTORS, ELECTROSTATIC DISCHARGE CAN CAUSE DAMAGE TO THE QUICK ACCESS RECORDER.
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 指示/記錄系統(tǒng) 1(77)