Control Display Unit - Annunciator Lamp Replacement
Figure 301
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-61-02
ALL ú ú 01 Page 307 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
CONTROL DISPLAY UNIT - REMOVAL/INSTALLATION
___________________________________________
1. General
_______
A. This subject has two tasks. The first task is to remove the Control Display Unit (CDU).
B. The second task is to install the CDU. This task includes a test of the installed CDU.
C. The CDUs are installed in the flight compartment on the forward electronic panel, P9, and the aft electronic panel, P8. The left CDU (CDU-L) and the right CDU (CDU-R) are installed in the forward electronic panel. The center CDU (CDU-C) is installed in the aft electronic panel.
TASK 34-61-02-004-017
2. Control Display Unit Removal
____________________________
A. References
(1)
09-11-00/201, Towing - Maintenance Practices
(2)
29-11-00/201, Main Hydraulic Supply System
B. Access
(1) Location Zone
221 Control Cabin, RH
222 Control Cabin, LH
C. Procedure
S 864-018
(1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
(a) P7 Overhead Circuit Breaker Panel
1) 7C1 FMCS FMC L
2) 7C2 FMCS CDU L
3) 7C23 FMCS FMC R
4) 7C24 FMCS CDU R
5) 7C3 FMCS CDU C
S 864-036
WARNING: MAKE SURE YOU REMOVE THE HYDRAULIC PRESSURE BEFORE YOU CHANGE
_______ THE POSITION FOR THE SPEED BREAK HANDLE OR THE LANDING GEAR HANDLE. INJURY TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(2)
Release the Hydraulic Pressure (Ref 29-11-00/201).
S 864-020
(3)
Pull the speed brake handle aft to the UP position if you are to remove the left CDU.
NOTE: The speed brake handle can cause a blockage when you remove
____
the left CDU.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-61-02
ALL ú ú 01 Page 401 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 864-050
WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
(4)
Install the ground locks in all landing gear if you are to remove the right CDU (Ref 09-11-00/201).
S 864-042
(5)
Move the landing gear handle to the OFF position if you are to remove the right CDU.
NOTE: The landing gear handle can cause a blockage when you remove
____
the right CDU.
S 024-003
CAUTION: DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS ON THE
_______ CONTROL DISPLAY UNIT. IF YOU TOUCH THESE CONDUCTORS, ELECTROSTATIC DISCHARGE FROM YOUR BODY CAN CAUSE DAMAGE TO THE CONTROL DISPLAY UNIT.
(6) Remove the CDU:
(a)
Release the fasteners on the front of the CDU.
(b)
Lift the handle and pull the CDU out until you can get access to the electrical connectors on the rear of the CDU.
(c)
Disconnect the electrical connectors from the CDU.
(d)
Install the dust caps on the electrical connectors.
TASK 34-61-02-404-022
3. Control Display Unit Installation
_________________________________
A. References
(1)
29-11-00/201, Main Hydraulic Supply System
(2)
IPC 34-61-02-01
B. Access
(1) Location Zone
221 Control Cabin, RH
222 Control Cabin, LH
C. Procedure
S 864-023
(1) Make sure these circuit breakers are open and DO-NOT-CLOSE tags are attached:
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 3(188)
