(2)  
AMM 24-22-00/201, Manual Control

 (3)  
AIPC 34-46-01 Fig. 1

 (4)  
AMM 34-46-00/501, Ground Proximity Warning System

 (5)  
AMM 34-46-00/201, Maintenance Practices

 B. Access
 (1)  Location Zone 117 Electrical and Electronics Compartment, LH 221/222 Control Cabin
 C. Procedure
 S 864-034
 (1)  Make sure these circuit breakers are open:
 (a)  P7 Overhead Circuit Breaker Panel
 1) 7D9 GND PROX WARN
 2) D06 TERR DSPL

 S 424-035
 CAUTION:  DO NOT TOUCH THE CONNECTOR PINS OR OTHER CONDUCTORS ON THE
_______ GROUND PROXIMITY WARNING COMPUTER. IF YOU TOUCH THESE CONDUC-TORS, ELECTROSTATIC DISCHARGE FROM YOUR BODY CAN CAUSE DAMAGE TO THE GROUND PROXIMITY WARNING COMPUTER.
 (2)  
Do this task to install the ground proximity warning computer: "Rack-Mounted Electrical/Electronic Module Installation" (AMM 20-11-22/401).

 S 864-025

 (3)
Remove the DO-NOT-CLOSE tag and close these circuit breakers:

 (a)  P7 Overhead Circuit Breaker Panel
 1) 7D9 GND PROX WARN
 2) D06 TERR DSPL

 D. GPWC Test
 S 864-026
 (1)  Supply electrical power (AMM 24-22-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-46-01
 ALL  ú ú 06 Page 402 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
 (2)  S 744-033If it is your airline's policy to do a check of the terrain database version, then do this task: Verify the Terrain Database part number (AMM 34-46-00/201).
 (3)  S 744-031Make sure the green COMPUTER OK light on the front panel of the GPWC is on.
 (4)  S 864-036Do this task:  GPWS - Operational Test (AMM 34-46-00/501).
 (5)  S 864-027Remove electrical power if it is not necessary (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 34-46-01
 ALL  ú ú 02 Page 403 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 GROUND PROXIMITY WARNING MODULE - SERVICING (BULB REPLACEMENT)
______________________________________________________________
 1.  General
_______
 A.  This subject has one task. The task is for the replacement of the light bulbs in the switch/indicator for the GPWS module. It is also necessary to do a test of the bulb operation.
 TASK 34-46-02-023-015
 2.  Ground Proximity Warning Module Switch/Indicator Bulb Replacement
_________________________________________________________________
 A.  Standard Tools and Equipment
 (1)  Lamp - 5 volts, 60ma - P/N MS24515-685
 B.  References
 (1)  
IPC 34-46-00 Fig. 1

 (2)  
24-22-00/201, Manual Control

 C.  Access
 (1)  Location Zone
 222 Control Cabin, RH

 D.  Procedure
 S 863-010
 (1) Open these circuit breakers and attach DO-NOT-CLOSE tags:
 (a)  
P7 Overhead Circuit Breaker Panel
 1) 7D9 GND PROX WARN

 (b)  
P6 Main Power Distribution Center
 1) 6E23 FLT DK LIGHTS PANEL F/O

 S 963-016
 CAUTION: DO NOT USE PLIERS OR OTHER TOOLS TO REMOVE THE CAP
_______ ASSEMBLIES. THIS CAN CAUSE DAMAGE TO THE SWITCH CAP.
 (2)  Replace lamps:
 (a)  
Hold the cap assembly tightly on the two sides and pull the assembly out of the switch.

 (b)  
Turn the cap assembly to get access to the lamps.

 (c)  
Remove lamps from the cap assembly.

 (d)  
Install the replacement lamps.

 (e)  
Turn the cap and put the cap assembly into the switch.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 導航 NAVIGATION 3(32)