EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-13-04
 ALL  ú ú 01 Page 203 ú Mar 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 (2)  Access Panels
 732/742 Main Landing Gear Body Door

 D. Install the Valve.
 S 032-010
 (1)  
Remove the covers from the openings and clean the mating surfaces of the valve, the new seal plates, and the assembly unit with hydraulic fluid. Do not let hydraulic fluid to get into the connector.

 S 432-011

 (2)  
Install the valve and the new seal plate on the servo unit.

 S 432-012

 (3)  
Install the mounting screws with grease.

 (a)  Tighten the screws to 60 inch-pounds.
 S 432-013
 (4)  Put a lockwire on the mounting screws.
 E. Test the ALCS Electrohydraulic Servovalve and Solenoid Valves
 S 862-014
 (1)  
Supply electrical power (Ref 24-22-00).

 S 862-015

 (2)  
Remove the DO-NOT-CLOSE tags and close these circuit breakers on the P11 panel:

 (a)  
11E17, FLT CONT COMPUTER POWER LEFT

 (b)  
11E18, FLT CONT COMPUTER SERVO LEFT

 (c)  
11E20, FLIGHT CONT CMPTR PWR CENTER

 (d)  
11E21, FLIGHT CONT CMPTR SERVO CENTER

 (e)  
11E35, FLT CONT CMPTR PWR RIGHT

 (f)  
11E36, FLT CONT CMPTR SERVO RIGHT

 S 862-016
 WARNING: KEEP PERSONS AND EQUIPMENT AWAY FROM ALL CONTROL SURFACES WHEN
_______ HYDRAULIC POWER IS SUPPLIED. AILERONS, ELEVATORS, RUDDER, FLAPS, SLATS, SPOILERS, AND STABILIZER ARE FULLY POWERED SURFACES. INJURY OR DAMAGE CAN OCCUR WHEN HYDRAULIC POWER IS SUPPLIED.
 (3)  Pressurize the left, center, and right hydraulic systems (Ref 29-11-00).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-13-04
 ALL  ú ú 01 Page 204 ú Mar 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 982-017
 (4)  
Manually operate the aileron three or more times.

 S 862-018

 (5)
Make sure these circuit breakers on the P11 panel are also closed:

 (a)  
11C30, LANDING GEAR POS SYS 1

 (b)  
11E16, MODE CONT PNL LEFT

 (c)  
11E34, MODE CONT PNL RIGHT

 (d)  
GUN 001-050, 052-999;
 11S4, MAINT CONT DSPL

 (e)  
GUN 051;
 11S6, MAINT CONT DSPL

 (f)  
11S15, AIR/GND SYS 1

 (g)  
11S19, AIR/GND SYS 2

 (h)  
11S23, POS SYS 2

 S 712-019
 (6)  
Do MCDP Ground Test 07 - SERVO AIL (Ref 22-00-02).

 S 862-012

 (7)  
Remove the pressure from the L, C, and R hydraulic systems.

 S 212-011

 (8)
Examine the valves for hydraulic leaks and fix them as necessary.

 F. Put the Airplane Back to its Usual Condition
 S 862-021
 (1)  
Set the MCDP to off.

 (2)
Remove hydraulic power if it is not necessary (Ref 29-11-00).

 (3)
Remove electrical power if it is not necessary (Ref 24-22-00).

 S 862-022
 S 862-023
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-13-04
 ALL  ú ú 14 Page 205 ú Mar 20/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
 AILERON CONTROL FORCE TRANSDUCER - REMOVAL/INSTALLATION
_______________________________________________________
 1.  General_______
 A.  The aileron Control Force Transducers (CFT) are on the pilot's (left) and the first officers (right) drum assembly. Get access to them through the access door, 113AL (Ref 06-41-00).
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 2(5)