S 394-052

 (3)  
Replace the doubleback tape. Make sure the doubleback tape are on all the edges and in strips with four-inch centers (direction optional).

 S 394-053

 (4)  
Apply the grease at the seat tracks.

 S 394-054

 (5)  
Apply two inches of BMS 5-95 sealant on the grease at each end of the seat track.

 S 114-055

 (6)  
Clean the top of the seat track with aliphatic naphtha and put the polyethylene tape on the seat track.

 (7)  
Install the trim on the floor mat.

 (8)
Put the floor mat in the position and apply strong pressure.

 S 394-058

 (9)  
Apply the RTV108 sealant to the trim, cracks and holes to seal the edges.

 S 424-111
 S 864-057
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-27-01
 ALL  ú ú 01 Page 408 ú May 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 424-112
 (10)
 Install the retainers and the screws.

 S 424-060

 (11)
 Install the passenger seats if it is necessary (AMM 25-25-01/201)

 S 424-061

 (12)
 For the forward floor mats and the aft floor mats, install the closet if it is necessary (AMM 25-24-02/401).

 S 394-062

 (13)
 Install the warning tape and the nonskid tape (Fig. 402).

 NOTE: Make sure you install the warning tape before you install the
____
 nonskid tape.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-27-01
 ALL  ú ú 01 Page 409 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 FLOOR PROXIMITY ESCAPE PATH LIGHTING RACEWAY - REMOVAL/INSTALLATION
___________________________________________________________________
 1.  General
_______
 A.  This procedure contains two tasks:
 (1)  
The first task is the removal of the floor proximity path lighting raceway.

 (2)  
The second task is the installation of the floor proximity path lighting raceway.

 B.  Use this procedure if it is necessary to replace parts or to get access to the adjacent equipment.
 C.  The floor proximity path lighting raceway is referred to as the raceway in this procedure.
 TASK 25-27-31-004-001
 2.  Floor Proximity Path Lighting Raceway - Removal (Fig. 401)
_______________________________________________
 A.  References
 (1)  
AMM 25-25-01/201, Passenger Seats

 (2)  
AMM 25-27-01/401, Floor Covering

 B.  Access
 (1)  Location Zone
 200 Upper Half of Fuselage

 C.  Procedure
 S 014-003
 (1)  
Remove the passenger seats (AMM 25-25-01/201).

 S 014-004

 (2)  
Remove the floor covering (AMM 25-27-01/401).

 S 034-005

 (3)  
Remove the sleeving which is on the wires.

 (4)  
Remove the tape that attaches the wires to the floor.

 (5)  
Disconnect the wires.

 (6)  
Lift and remove the raceway from the floor.

 S 034-006
 S 024-007
 S 024-008
 NOTE: For easy installation of the raceway, make a note of the
____ location where you remove the raceway.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH FLOOR PROXIMITY ESCAPE ú

 25-27-31
 PATH LIGHTING RACEWAYS  ú ú 01 Page 401 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
LENS COVER EDGE LIGHTING
CLEAR LENS ELECTRICAL WIRE 1
LIGHT BULB ELECTRICAL WIRE 1
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(74)