S 412-040

 (6)  
Put the PSU back in position (Ref 25-23-01).

 S 202-048

 (7)  
Close the door. Make sure the door latches correctly.

 S 202-049

 (8)  
Make sure the two latching pawls are fully engaged with the strikers.

 S 222-050

 (9)  
Make sure the distance between the actuating-push-handle and the latch housing is 0.24 |0.03 inch.

 TASK 25-28-01-002-041
 6. Open the Overhead Stowage Bin Door That Does Not Operate (Fig. 201)
________________________________________________________
 A. Access
 (1)  Location Zones
 200 Upper Half of Fuselage

 B. Procedure
 S 822-052
 (1)  Put a small diameter rod (less than 0.11 inch) in the manual release hole. Push the small diameter rod to release the latch.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-28-01
 ALL  ú ú 03 Page 207 ú Dec 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
 OVERHEAD STOWAGE BIN - REMOVAL/INSTALLATION
___________________________________________
 1.  General_______
 A. This procedure contains the following tasks.
 (1)  
Remove the overhead stowage bin.

 (2)  
Install the overhead stowage bin.

 TASK 25-28-02-004-002
 2.  Remove the Overhead Stowage Bin (Fig. 401)_______________________________
 A. References
 (1)  
AMM 21-61-08/401, Zone Temperature Sensor

 (2)  
AMM 25-22-01/401, Sculptured Ceiling Panel

 (3)  
AMM 25-22-02/401, Lowered Ceiling Panel

 (4)  
AMM 25-23-01/401, Passenger Service Units

 (5)  
AMM 33-21-10/201, Passenger Compartment Illumination

 (6)  
AMM 33-51-05/201, Aisle Lights

 B. Access
 (1)  Location Zone
 200 Upper Half of Fuselage

 C. Procedure
 S 024-100
 (1)  
Remove the sculptured ceiling panel (AMM 25-22-01/401).

 S 024-101

 (2)  
Remove the lowered ceiling panel (AMM 25-22-02/401).

 S 024-196

 (3)  
Remove the fluorescent light if it is installed (AMM 33-21-10/201) and disconnect the electrical connector.

 S 024-102

 (4)  
Remove the PSU and spacer panels (AMM 25-23-01/401).

 (5)  
Remove the screws on the outboard side of the bullnose.

 (6)  
Remove the emergency aisle light (AMM 33-51-05/201).

 S 024-104

 (7)  
Remove the zone temperature sensor if it is installed (AMM 21-61-08/401).

 (8)  
Remove the bullnose

 S 024-199

 (9)  
Remove the alignment pins between the adjacent overhead stowage bins.

 S 024-197
 S 024-103
 S 024-105
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-28-02
 ALL  ú ú 01 Page 401 ú Jan 20/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL

B-B
Overhead Stowage Bin Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-28-02
 ALL  ú ú 01 Page 402 ú Jan 20/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
 S 024-200
 (10)
 Remove the bolts, washers, bushings, and nuts to disconnect the lower turnbuckles.

 S 024-201

 (11)
 Remove the bolt, washer, and nut to disconnect the diagonal strut at the top, outboard edge of the overhead stowage bin.

 S 024-202

 (12)
 Hold the overhead stowage bin and remove the bolts, washers, bushings, and nuts to disconnect the top turnbuckles.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 1(79)