曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

____ connected by a lanyard. If the safety pin set is not available, you can use 2 bolts (3/16-inch diameter by 1 1/4-inch grip) as an alternative. Install one bolt above and one bolt below the knife assembly plunger. Attach streamers to the bolts to identify the bolts for removal.
 C. Consumable Materials
 (1)  D00210 Grease - Light Consistency DC-33
 D. Parts
 (1)  This table is for the No. 1 passenger door.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 10 Page 412 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL

 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT | FIG | ITEM | ................................................................................ | 402 | 1 | Slide-Raft Pack | 25-66-01| 01 | 95 | | 401 | 2 | Cover (Left Door) | | | 100 | | | | Cover (Right Door) | | | 105 | | 402 | 3 | Girt Bar | 25-66-05| 05 | 110 | | | 4 | Bar Lock | | | 45 | 2......…........…...................................…..........….....….........1
 (2) This table is for the No. 2 passenger door.
 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT | FIG | ITEM | ................................................................................ | 402 | 1 | Slide-Raft Pack | 25-66-01| 02 | 93 | | 401 | 2 | Cover (Left Door) | | | 94 | | | | Cover (Right Door) | | | 99 | | 402 | 3 | Girt Bar | 25-66-05| 05 | 110 | | | 4 | Bar Lock | | | 45 | 2......…........…...................................…..........….....….........1
 (3) This table is for the No. 4 passenger door.
 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT | FIG | ITEM | ................................................................................ | 402 | 1 | Slide-Raft Pack | 25-66-01| 04 | 93 | | 401 | 2 | Cover (Left Door) | | | 95 | | | | Cover (Right Door) | | | 100 | | 402 | 3 | Girt Bar | 25-66-05| 05 | 110 | | | 4 | Bar Lock | | | 45 | 2......…........…...................................…..........….....….........1
 E. References
 (1) AMM 25-66-10/201, Girt Bar
 F. Access
 (1)  Location Zones
 831 No. 1 passenger door (Left)
 832 No. 2 passenger door (Left)
 836 No. 4 passenger door (Left)
 841 No. 1 passenger door (Right)
 842 No. 2 passenger door (Right)
 846 No. 4 passenger door (Right)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-01
 ALL  ú ú 08 Page 413 ú May 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 G. Install Escape Slide (Fig. 402)
 S 434-050
 (1)  If you install a new slide pack (1), do these steps:
 (a)  
Make sure the release strap goes through the release strap guide ring as shown (Fig. 403).

 (b)  
Install the release strap/latch chain fastener to attach the harness latch and chain assembly to the release strap.

 NOTE:____Make sure the chain length is 4 chain links. If a split ring is installed on the chain, make sure it is correctly soldered. If a clevis is installed on the chain, make sure that it can turn without limits in the latch assembly.

 (c)  
Remove the girt bar (3) and the bar locks (4) from the floor fittings.

 (d)  
Install the girt bar (3) in the girt (AMM 25-66-10/201).

 S 164-053
 (2)  
Use a clean cloth to wipe clean all mating surfaces on the floor fittings and the bar locks (4).

 S 164-054

 (3)  
Use a clean cloth to wipe clean all mating surfaces on the bar locks (4) and the girt bar end fittings.

 S 644-055

 (4)  
Apply a thin layer of grease to all mating surfaces on the floor fittings and the bar locks (4).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(79)