EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-03
 ALL  ú ú 01 Page 404 ú May 28/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 TASK 25-66-03-404-012
 3.  Install Escape Slide (Fig. 401)____________________
 A. Access
 (1)  Location Zones
 835 No. 3 Emergency Exit Door (Left)
 845 No. 3 Emergency Exit Door (Right)

 B. Procedure
 S 214-002
 WARNING: MAKE SURE THE SAFETY PIN IS INSTALLED ON THE SLIDE PACK BEFORE
_______ YOU MOVE THE SLIDE PACK. WITHOUT THE SAFETY LOCK PIN INSTALLED, THE SLIDE CAN INFLATE ACCIDENTALLY AND CAUSE INJURY OR DAMAGE.
 (1)  Make sure the safety pin in installed in the inflation cylinder on the slide pack.
 S 214-003
 WARNING: MAKE SURE THE WHITE NEEDLE ON THE PRESSURE GAGE ON THE SLIDE
_______ PACK IS IN THE GREEN "GO" BAND. THIS SHOWS THAT THE GAS RESERVOIR IS SUFFICIENTLY CHARGED. THE ESCAPE SLIDE WILL NOT INFLATE IN AN EMERGENCY IF THE GAS RESERVOIR IS NOT SUFFICIENTLY CHARGED.
 (2)  
Make sure the white needle on the pressure gage on the slide pack is in the green GO band.

 S 424-013

 (3)  
Install the slide pack in the slide compartment on the No. 3 emergency exit door.

 S 424-014

 (4)  
Install the four fasteners to attach the slide pack to the emergency exit door.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-03
 ALL  ú ú 01 Page 405 ú Dec 20/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 (5)  S 034-015If the girt bar was temporarily put into the floor fittings, then remove the girt bar from the floor fittings.
 (6)  S 434-016Push the girt bar through the loop in the girt.
 (7)  S 434-017Install the ends of the girt bar into the floor fittings.
 S 034-018

 WARNING: MAKE SURE YOU REMOVE THE SAFETY PIN FROM THE SLIDE PACK AFTER
_______ YOU INSTALL THE SLIDE PACK ON THE DOOR. THE ESCAPE SLIDE WILL NOT INFLATE IN AN EMERGENCY IF THE SAFETY PIN IS INSTALLED.
 (8)  
Remove the safety pin from the inflation bottle regulator on the slide pack.

 S 434-019

 (9)  
Put the safety pin into the stowage pouch on the front of the slide pack.

 S 414-020

 (10)
 Install the slide cover.

 (a)  
Hang the cover on the upper hinge, and turn the bottom of the cover in the outboard direction.

 (b)  
Push on the bottom center of the cover in the outboard direction to engage the lower latch.

 (c)  
Continue to push the bottom of the cover in the outboard direction until the cover is in the correct position.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-03
 ALL  ú ú 01 Page 406 ú Dec 20/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 NO. 3 EMERGENCY EXIT DOOR ESCAPE SLIDE - INSPECTION/CHECK
_________________________________________________________
 1.  General_______
 A.  This procedure contains two tasks.
 (1)  
The first task is to examine the escape slide and the girt bar on the No. 3 emergency exit door.

 (2)  
The second task is to examine the inflation cylinder pressure gage.

 B.  Task two is included in task one. Thus, if you do task one, then it is not necessary to do task two.
 TASK 25-66-03-206-001
 2.  Examine No. 3 Emergency Exit Door Escape Slide______________________________________________
 A.  References
 (1)  25-66-03/401, No. 3 Emergency Exit Door Lining

GREEN BAND

PRESSURE GAGE NEEDLE
PRESSURE GAGE

A
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(84)