757 MAINTENANCE MANUAL
 (3)  This table is for the No. 4 Passenger Door.
 ~.............................................................................. | MM | | IPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT | FIG | ITEM | ................................................................................ | 201 | 1 | Girt Bar | 25-66-05| 05 | 135 | | | 2 | Escape Slide-Raft | 25-66-01| 04 | 93 | | 202 | 3 | Screw | | | 365 | | | 4 | Retainer Plate | | | 360 | 2......…........…...................................…..........….....….........1
 E. References
 (1) 25-66-01/401, No. 1, 2, and 4 Passenger Door Escape Slides.
 F. Access
 (1)  Location Zones
 831 No. 1 Passenger Door (Left)
 832 No. 2 Passenger Door (Left)
 836 No. 4 Passenger Door (Left)
 841 No. 1 Passenger Door (Right)
 842 No. 2 Passenger Door (Right)
 846 No. 4 Passenger Door (Right)

 G. Procedure
 S 422-023
 CAUTION:_______BE CAREFUL WHEN YOU INSTALL THE GIRT BAR. DAMAGE TO THE LEAF SPRINGS CAN EASILY OCCUR.
 (1)  
Carefully install the girt bar (1) into the girt while you remove the dummy girt bar.

 S 432-003

 (2)  
If it is necessary, remove the tape from the leaf springs and the girt bar.

 S 432-024

 (3)  
Install the loop which is on the end of the static line around the end of the girt bar (1).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-10
 ALL  ú ú 03 Page 208 ú Sep 28/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
 S 422-093
 CAUTION: MAKE SURE THAT THE LENGTH OF THE STATIC LINE BETWEEN THE PACK
_______ AND THE GIRT BAR IS THE MINIMUM LENGTH NECESSARY. TOO MUCH STATIC LINE WILL CATCH ON THE GIRT BAR. YOU WILL NOT BE ABLE TO ARM THE DOOR.
 (4)  
Put the extra length of the static line into its stowage pocket.

 S 432-025

 (5)
Fold the flap around the static line and attach the velcro.

 S 432-026

 (6)  
Attach the retainer plate (4) to the girt bar (1) with the screws (3).

 S 432-027

 (7)
Fold the cover flap around the girt bar and attach the velcro.

 S 412-028

 (8)  
Install the escape slide (2) (Ref 25-66-01). Do not remove the safety pin from the inflation cylinder regulator. Do not install the cover for the escape slide (2).

 S 712-031

 (9)
Do a check of the girt bar (1) for the correct operation.

 S 092-032

 (10)
 Remove the safety pin from the inflation cylinder regulator.

 S 432-033

 (11)
 Put the safety pin into the stowage pouch on the escape slide (2).

 S 412-036

 (12)
 Install the cover for the escape slide (2) (Ref 25-66-01).

 TASK 25-66-10-202-039
 4.  Examine the Girt Bar and Floor Fittings_______________________________________
 A. General
 (1)  In this task an escape slide or slide-raft is referred to as an escape slide.
 B. References
 (1)  25-66-01/401, No. 1, 2, and 4 Passenger Door Slides
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 25-66-10
 ALL  ú ú 03 Page 209 ú Sep 28/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL

 C. Access
 (1)  Location Zones
 831 No. 1 Passenger Door (Left)
 832 No. 2 Passenger Door (Left)
 836 No. 4 Passenger Door (Left)
 841 No. 1 Passenger Door (Right)
 842 No. 2 Passenger Door (Right)
 846 No. 4 Passenger Door (Right)

 D. Procedure
 S 862-040
 (1)  
Move the mode selector lever to the DETACH position.

 S 012-043

 (2)  
Remove the cover for the escape slide (2) (Ref 25-66-01).

 S 032-046

 (3)  
Remove the safety pin from the stowage pouch on the escape slide (2).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 EQUIPMENT/FURNISHINGS 2(88)