S 434-045
(15)
Install the connecting rods between the APCS and the torque tube cranks on the captain's aft quadrant (3 locations).
S 434-046
(16)
Install the two control rods between the neutral shift and override mechanism and the elevator feel unit.
S 434-047
(17)
Install the two connecting rods between the elevator feel unit and the aft quadrant flanges and tighten the nuts as follows:
(a)
Tighten the inner nut to 50-60 pound-inches (5.6-6.7 Nm).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-16
ALL ú ú 01 Page 410 ú Jan 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
(b) Tighten the outer nut to 10 pound-inches (1.1 newtons).
NOTE: Do not try to tighten the inner nut after you tighten
____
the outer nut.
S 094-048
(18)
Remove the identification tags and install the captain's and the first officer's elevator control cables to the aft quadrants (Ref 27-00-01).
S 824-049
(19)
Do the adjustment for the elevator control cables (Ref 27-31-00).
S 864-050
(20)
Remove the DO-NOT-CLOSE tags and close these circuit breakers on the overhead panel, P11:
(a)
11B19, STAB TRIM ALT (IF INSTALLED)
(b)
11C12, STAB TRIM SHUTOFF LEFT
(c)
11C13, STAB TRIM SHUTOFF RIGHT
(d)
11H11 or 11C05, STAB TRIM CONT L
(e)
11H17, FLT CONT SHUTOFF TAIL LEFT
(f)
11H18, FLT CONT SHUTOFF TAIL CTR
(g)
11H20, STAB TRIM CONT R
(h)
11H28, FLT CONT SHUTOFF TAIL RIGHT
S 864-051
(21)
Put the RIGHT and CENTER STAB TRIM SHUTOFF valve switches on the control stand panel, P10, to the NORM position.
S 864-052
(22)
Put the L, R and C FLT CONTROL SHUTOFF switches on the right side panel, P61, to the ON position.
S 824-053
(23)
Do the adjustment for the neutral shift and override mechanism (Ref 27-31-21).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-16
ALL ú ú 01 Page 411 ú Jan 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
S 824-054
(24)
Do the adjustment for the elevator feel unit (Ref 27-31-17).
S 714-055
(25)
Do the test for the elevator feel system (Ref 27-31-00).
S 714-056
(26)
Do the test for the neutral shift and override mechanism
(Ref 27-31-00).
S 824-057
(27)
Do the adjustment for the autopilot pitch control servo mechanism (Ref 22-12-01).
S 714-058
(28)
Do the test for the autopilot pitch control servo mechanism (Ref 22-12-01).
E.
Put the Airplane Back to Its Usual Condition
S 864-059
(1)
Remove electrical power, if it is not necessary (Ref 24-22-00).
S 414-060
(2)
Close the access door for the forward stabilizer compartment, 311AL (Ref 06-42-00).
(3)
Close the access panel for the aft quadrants, 313AL (Ref 06-42-00).
S 414-061
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
27-31-16
ALL ú ú 01 Page 412 ú Dec 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
ELEVATOR FEEL UNIT - MAINTENANCE PRACTICE
_________________________________________
1. General_______
A. This procedure contains steps to remove and install the feel unit for the elevator control system and remove and install of the feel unit roller bearing.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 3(113)
