*
Select the DESTINATION
*
Select the SOURCE.
*
The data loader is prepared for operation. Select START.
EFFECTIVITY BEJ ALL 45-10-00
Page 98.64
D633W101-BEJ Sep 05/2002
CMCS -DATA LOAD MAIN DISPLAY
*
The data load is in progress.
*
The data load is stopped.
*
The data load is complete.
Select the DESTINATION shows when both the source indication and destination data fields are blank.
Select the SOURCE shows when the source indication and data field is blank.
When the data load process is ready to start, this shows:
* The data loader is prepared for operation. Select START.
When data transfer starts between the CMCF and the destination LRU/LRM, this shows:
* The data load is in progress.
When the data load process stops, this shows:
* The data load is stopped.
When the data load process is successful, this shows:
* The data load is complete. Select another source or another destination.
System Configuration List Box
The system configuration list box and box title shows information based on the system selection on the destination selection dialog box. The box shows:
*
LRU/LRM identifier
*
Hardware part number
*
LRU serial number
*
Software part number(s).
When the destination indication field is empty, the system configuration list box is empty.
Buttons
These are the three buttons that show on the data load main display:
*
SELECT SOURCE
*
SELECT DESTINATION
*
START.
SELECT SOURCE shows next to the source indication field.
Select SELECT SOURCE to show the source selection dialog box.
The selection is not available during the data load process.
EFFECTIVITY BEJ ALL 45-10-00
Page 98.65
D633W101-BEJ Sep 05/2002
CMCS -DATA LOAD MAIN DISPLAY
SELECT DESTINATION shows next to the destination indication
data field.
Select SELECT DESTINATION to show the destination selection
dialog box.
The selection is not available during the data load process.
START shows next to the data load status field.
Select START to begin the data load process.
At initial power-up, the START selection is not available. The
START selection becomes available when this load status indication shows:
* The data loader is prepared for operation. Select START.
EFFECTIVITY BEJ ALL 45-10-00
Page 98.66
D633W101-BEJ Sep 05/2002
777 AIRCRAFT MAINTENANCE MANUAL
CMCS -DATA LOAD MAIN DISPLAY
EFFECTIVITY BEJ ALL 45-10-00
Page 98.67
D633W101-BEJ Sep 05/2002
777 AIRCRAFT MAINTENANCE MANUAL
THIS PAGE IS INTENTIONALLY LEFT BLANK
45-10-00
Page 98.68 D633W101-BEJ Jan 05/2002
CMCS -DATA LOAD SOURCE SELECTION DIALOG BOX
General
The source selection dialog box lets you select a specific data source and a load part number for software data loading.
The source selection dialog box shows these functions:
*
Title
*
Source selection list box
*
Load part number list box
*
Buttons.
Title
The first line of the title always shows DATA LOAD. The second line of the title shows Set Source.
Source Selection List Box
The title of the source selection list box is Select the Data Source.
The source selection list box shows the list of sources for the software. The source is one of these:
*
MAT hard drive
*
MAT disk drive
*
PMAT disk drive.
Select the source first. Data does not show in the load part number list box until a selection is made.
EFFECTIVITY
BEJ ALL
The selection of a source causes that source to show on the data load main display in the source indication field.
Load Part Number List Box
The title of the load part number list box is Select the Load Part Number.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 中央維護 Central Maintenance(37)
