*
Report number
*
Date and time sent
*
Airplane tail number
*
Flight number
*
Flight origin and destination
*
CPM/COMM OPS part number
*
Active CMCF.
These are the codes for report type:
*
IFDE: Inbound FDE summary report
*
EFDE; Existing FDE summary report
*
TEST; Ground test report
*
CFG; System configuration summary report
*
PLF; Present leg fault summary report
*
EF; Existing faults summary report
*
DL; Data load reports
EFFECTIVITY
BEJ ALL
*
IMM; Inbound maintenance memo summary report
*
EMM; Existing maintenance memo summary report
*
ISMT; Inbound scheduled maintenance task summary report
*
ESMT; Existing scheduled maintenance task summary report
*
IMON; Input monitoring report
*
OPT; Central maintenance options report
*
ENG; Engine balancing report
*
SFLIST; Shop fault list of contents report
*
SFDATA; Shop fault data report
*
PSEU; PSEU rigging/calibration report
*
AGRIG; Air/ground rigging report
*
SPEC; Special function report
*
MSG; Single maintenance message report
*
NOTES; Notes report
*
HELP; Help report.
The report number is the number of reports sent to the ground during the present flight leg.
The active CMCF shows as L for left and R for right.
FDE Summary Groups
Flight deck effect (FDE) summary groups start with the code FDE. They also have the:
*
Fault code
*
FDE activity
*
Time and date the FDE first occurred.
The codes for FDE activity are:
45-10-00
Page 98.235 D633W101-BEJ Sep 05/2002
CMCS -DOWNLINK REPORTS
*
A; active
*
I; not active
*
L; latched
*
N; no activity.
Maintenance Message Summary Groups
Maintenance message summary groups start with the code MSG. They also have the:
*
Maintenance message number
*
Maintenance message activity
*
Time and date the maintenance message first occurred
*
Flight phase
*
Intermittence
*
Intermittence number
*
Previous leg identifier
*
Detected by identifier.
The codes for maintenance message activity are the same as for FDE activity.
These are the codes for flight phase activity:
*
PO; Power on
*
ES; Engine start
*
TA; Taxi out
*
TO; Take off
*
IC; Initial climb
*
CL; Climb
*
ER; Cruise
*
DC; Descent
*
AP; Approach
*
GA; Go around
*
FL; Flare
*
RO; Rollout
*
TI; Taxi in
*
SD; Shutdown
*
MT; Maintenance.
These are the codes for intermittence:
*
H; Hard
*
I; Intermittent
*
M; Mode dependent.
If the fault occurred in a previous leg, PL will show.
The LRU that detects the fault shows after the code DB.
Correlated FDEs and Maintenance Messages
The summary groups for maintenance messages correlated to FDEs show after the FDE summary groups.
EFFECTIVITY BEJ ALL 45-10-00
Page 98.236
D633W101-BEJ Sep 05/2002
777 AIRCRAFT MAINTENANCE MANUAL
CMCS -DOWNLINK REPORTS
EFFECTIVITY BEJ ALL 45-10-00
Page 98.237
D633W101-BEJ Sep 05/2002
777 AIRCRAFT MAINTENANCE MANUAL
THIS PAGE IS INTENTIONALLY LEFT BLANK
45-10-00
Page 98.238 D633W101-BEJ Sep 05/2002
CMCS -MAINTENANCE ACCESS TERMINAL -SYSTEM TESTS
General
These are the six system tests for the maintenance access terminal (MAT):
*
MAT Display Unit System Test
*
MAT Display Brightness System Test
*
MAT Display Unit Graphical Pattern System Test
*
MAT Cursor Control Unit System Test
*
MAT Standard Disk Drive System Test
*
MAT AVLAN System Test.
MAT Display Unit System Test
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 中央維護 Central Maintenance(69)
