曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

when aircraft are getting closer.
ITP Aircraft  Aircraft:
- Fully qualified in terms of equipment, operator, and flight crew qualification to conduct an ITP
- That considers a flight level change.
ITP Criteria  Refer to C.2.6 – ITP Criteria. 
ITP Distance  Refer to C.2.5 – ITP Distance. 
ITP Volume  Refer to C.2.3 – ITP Volume. 
Other Aircraft  Aircraft that are not either the ITP aircraft or the Reference 
Aircraft. 
Qualified  ADS-B  ADS-B data that meet accuracy and integrity requirements 
data  for ITP. 

Reference Aircraft  One or two aircraft in the ITP volume but not at the desired flight level:
- With qualified ADS-B data
- 
That meet the ITP criteria

- 
That will be identified to ATC by the ITP Aircraft in the ITP clearance request.

Same Direction  Refer toC.2.2 – Aircraft on the Same Direction.
C.2. PROCEDURE
C.2.1. ITP SEQUENCE
1.  To initiate an ITP maneuver, the flight crew must check that the ITP criteria (refer to C.2.6 – ITP Criteria) are met. The ITP criteria ensure that the ITP Aircraft and the Reference Aircraft do not get closer than the ITP separation minimum (10 NM).

Figure C - 1: ITP separation minimum
2.  
When the ITP criteria are met, the flight crew may request an ITP clearance. The ITP request contains the identification of the Reference Aircraft and the range to these aircraft. The ATC controller checks that conditions are met to maintain safe separations between ITP and Reference Aircraft.

3.
When these conditions are  met, the ATC controller may deliver the clearance.

4.  
When the ATC clearance is received, the flight crew must re-check that the ITP speed/distance criteria are still met before initiating the ITP maneuver.

 

C.2.2. AIRCRAFT ON THE SAME DIRECTION
The definition of the term Same Direction is derived from the term Same Track given in ICAO PANS-ATM, Doc 4444 (see References).
Aircraft are on a same direction when the difference of track angles is:
- Less than 45°, or
-More than 315°. Refer to Figure C - 2.
C.2.3. ITP VOLUME
The ITP criteria apply to aircraft that are in the ITP volume. The ITP volume is centered on the ITP Aircraft and defined as follows:
- Height: 4 000 ft above the aircraft in
Figure C - 2: Same direction
climb or below the aircraft in descent.
- Length: 160 NM. It is equal to procedural longitudinal separations (10 min or 80 NM) behind and ahead of the aircraft.
- Width: 40 NM. This width ensures that aircraft on parallel tracks are excluded of the ITP process (e.g. when lateral separations of 30 NM are applied).

 

　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：getting to grips with surveillance(123)