(k)  
Put the forward and aft cages together and install the attaching bolts.

 S 865-112
 (29)
 Pressurize the right hydraulic system (AMM 29-11-00/201).

 S 865-114

 (30)
 Remove the RAT circuit breaker lock set and close the following circuit breakers on the P6 panel:

 (a)  
6F1, RAT MAN PWR or RAT MAN

 (b)  
6F2, RAT MAN CONT

 S 865-115
 (31) Remove the RAT circuit breaker lock set and close these circuit breakers on the P11 panel:
 (a)  
11D26, HYDRAULIC RAT AUTO CONT or HYDRAULIC RAT CONT

 (b)  
11D27, HYDRAULIC RAT AUTO PWR or HYDRAULIC RAT AUTO

 (c)  
EICAS (6 locations)

 S 085-119
 (32) If you installed tape on the hub or blade of the RAT turbine, remove the tape.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 29-21-00
 ALL  ú ú 07 Page 520 ú Jan 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL

 S 985-120
 (33) Do these steps to make sure the RAT turbine blades turn freely.
 (a)  Manually turn the RAT turbine blades to the fine-pitch position
 and release.
 (b)  Manually do a check that the RAT turbine blades move fully back
 to the coarse-pitch position .  If the RAT turbine blades do
 not return to the coarse-pitch position under the spring load,
 manually rotate the RAT turbine blades back to the coarse-pitch
 position .
 NOTE:____ The RAT turbine blades must be in the coarse-pitch
 position before you retract the RAT.

 S 825-116
 (34)
 Manually move the turbine hub to align the index mark on the hub with the index mark on the strut.

 S 865-117

 (35)
 Hold the ground manual switch in the up (stow) position until the RAT is fully retracted.

 S 215-118

 (36)
 Make sure the RAT UNLOCKED light on the engine-start/RAT-control panel is off.

 S 865-119

 (37)
 Push the STATUS switch on EICAS display select panel.

 S 215-120

 (38)
 Make sure the RAT UNLOCKED and RAT messages are not shown on EICAS.

 S 415-121

 (39)
 Install the access panel for the ground manual switch in the fairing on the aft bulkhead of the right wheel well.

 S 865-122

 (40)
 Put the reservoir depressurization valves in the right and center systems back to the closed (non-vented) position (AMM 29-11-00/201).

 S 415-123
 WARNING:_______REFER TO AMM 32-00-15/201 FOR THE LOCK REMOVAL PROCEDURE. FAST MOVEMENT OF THE DOORS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (41) Remove the door locks and close the landing gear doors (AMM 32-00-15/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 29-21-00
 ALL  ú ú 08 Page 521 ú May 28/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757 MAINTENANCE MANUAL
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 液壓 CHAPTER 29 - HYDRAULIC POWER 2(62)