曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 Instruction 1129, for belt tension adjustment.   
21-50 4) Check the belt of the vapor cycle cooling compressor (if installed) for condition and tension - refer to 21-50-01 201. 100  
 Check the tension of a new belt after the first 25 operating hours.   
28-20 S / N 1 - 730 100  
 5) Clean or replace the fuel filter located close to the electric pump, check the support - refer to 28-20-02 201.   
73-10 S / N 1 - 9999 100  
 6) Visually inspect the mechanical fuel pump. Check attach fittings and connections on the engine pump and the pressure switch.   
73-20 7) Remove and clean the injection pump fuel supply filter. 100  
 Install the filter - refer to 73-20-01 301.   
73-10 8) Visually inspect the flow distributor. 100  
73-00 9) Check the fuel system for leaks and security of the clamps. 100  
61-10 10) Check the grooved rubber on the de-iced propeller (if installed) for bonding and cleanliness - refer to 100  
 30-60-00 201.   
30-60 11) Check the fluid level of the propeller de-icing system (if installed) - refer to 30-60-00 201. 100  
30-60 12) Visually inspect the supply lines of the propeller de-icing system (if installed) for routing, and condition of attach fittings - refer to 30-60-00 201. 000  
37-00 13) Visually inspect the vacuum system vacuum pump, the unions, fittings and pipes (if installed). Check the drive for oil leaks. 100  

AIAA
Validity : S / N 1 - 9999 05-20 Page 205
03 (JA) JUN 01
 

ATA "2A" INSPECTION - 50 HOURS
ENGINE COMPARTMENT INSPECTION (AREA 100) AREA OTHER
INSPECTION PERFORMED
BY
74-20 14) Remove and thoroughly inspect the upper and lower spark plugs. If the spark plugs are fouled, clean and adjust gap, then permute upper and lower spark plugs -refer to 74-20-02 201. 100  
74-20 15) Check the conductors and the ceramics for corrosion and deposits. 100  
 Clean the cable ends, spark plug walls and ceramics with a dry clean cloth or a clean cloth moistened with methyl-ethyl-ketone. Dry.   
74-20 16) Check ignition harness clamps for security and spark plug and magneto terminals for tight connection. 100  
79-00 17) Visually inspect the lubrication lines and connections on the engine cases and on the oil cooler(s), check the attach fittings and look for impact marks, wear, cracks and leaks. 100  
71-60 18) Visually inspect the inlet pipes, the manifolds and their attach fittings. 100  
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(3)