AIAA
Validity : S / N 1 - 9999 05-20-05 (JA) Page 230
JUN 01
ATA "80A" MAJOR INSPECTION
STABILIZER INSPECTION (AREA 300) AREA OTHER
INSPECTION PERFORMED
BY
55-00 STABILIZER INSPECTION (AREA 300) 300
55-00 1) Perform an overall visual inspection of area 300. 300
11-00 2) Check installation and legibility of exterior placards and markings - refer to 11-20-00 1. 300
55-00 3) Check the control surfaces for freedom of rotation - refer to 27-10-00 201, 27-20-00 201 and 27-30-00 201. 300
55-00 4) Check the play of the elevator hinge ball joints - refer to 55-20-01 201. 300
55-20 5) Remove the elevator and inspect for loose rivets, cracks and evidence of corrosion - refer to 55-20-01 201. 300
Lubricate the inside of the balancing boom - refer to 12-21-03 201.
Visually inspect the elevator supports and hinges at frame C9.
Install the elevator - refer to 55-20-01 201.
55-20 6) Visually inspect the elevator hinge bearings. 300 1000 hrs or
S / N 1 - 1864, 1867 - 1869 2 years
Refer to the latest issue of SB 10-101-55.
55-20 7) Check the balancing weight and the boom for security and evidence of corrosion. 300
55-40 8) Remove the rudder. 300
Visually inspect the hinges and check for loose rivets, cracks and evidence of corrosion.
Install the rudder - refer to 55-40-00 201.
55-40 9) Check the balancing weight for attachment, and check for evidence of corrosion ; in case of doubt, remove the vertical stabilizer tip - refer to 55-40-00 201. 300
55-30 10) Visually inspect (do not remove) vertical stabilizer,
structure, attachments at frames C7 and C8, hinge bearings, skins and check for loose rivets, distortion, cracks and evidence of corrosion. 300
30-10 11) Visually inspect the porous leading edges (if installed) on the stabilizers. 300
27-20 12) Visually inspect the adjustable end of the rudder trim tab control (on control surface side). 300
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(45)
