曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

ailerons and stabilizers. If doubtful, check continuity and resistance - refer to 23-60-00 201.   
24-00 4) Visually inspect all cable connections in the L.H. wing. 500  
 Replace cables if damaged. Inspect cables for routing, clamp security, lugs and cleanliness.   
27-10 5) Visually inspect the roll control linkage in L.H. wing, inspect bellcranks, attaching hardware, check play, look for wear, interference and corrosion - refer to 27-10-00 201. 500  
27-50 6) Visually inspect (do not remove) the L.H. flap control rods. 500  
27-50 7) Remove and clean the L.H. flap control bellcrancks. 500 1000 hrs 
 Perform a detail examination. Lubricate. Install.   
27-50 8) Visually inspect (do not remove) the flap control linkage for security of attach fittings, play, evidence of wear, interference and corrosion - refer to 27-50-01 201. 000 1000 hrs 
27-30 9) Visually inspect the stall warning device, check attach fittings and connectors - refer to 27-30-04 201. 500  
28-10 10) Perform an operational test of the L.H. fuel tank cap and check the seal condition - refer to 28-10-00 301. 500  
12-10 11) Drain the fuel tanks and fuel system - refer to 000  
 12-11-02 301. Ventilate - refer to 12-11-03 301.   
28-10 12) Inspect the L.H. fuel tank for condition - refer to 500  
 28-10-00 601.   
28-10 13) Inspect the draining holes located on the non-sealed ribs of the L.H. fuel tank for partial or total obstruction with sealing compound or any other deposit. 500  
28-10 14) Inspect the draining holes located under the low level detector box (if installed) of the L.H. fuel tank for partial or total obstruction with sealing compound or any other deposit. 500  
28-10 15) Visually inspect the L.H. fuel tank air vent pipes for condition, security and obstruction. 500  

AIAA
Validity : S / N 1 - 9999 05-20-05 (JA) Page 218
JUN 01
 

ATA "80A" MAJOR INSPECTION
L.H. WING INSPECTION AREA 500) AREA OTHER
INSPECTION PERFORMED
BY
28-20 16) Visually inspect the fuel outlet union on the L.H. wing ; check the line, the support and the grommet ; clean the strainer - refer to 28-20-03 201. 500  
28-40 17) Remove the L.H. tank float gages (if installed). 500  
 Check the floats for porosity and travel, check the tracks and the seal for condition.   
 Install the float gages - refer to 28-40-01 401.   
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB 20 MAINTENANCE MANUAL 05 TIME LIMITS MAINTENANCE CHECKS TB20飛機維護手冊 05 時間限制維護檢查 2(34)