曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (d)  Do this task:  Remove Electrical Power (AMM 24-22-00/201).
 TASK 31-31-03-402-016
 5.  Flight Data Acquisition Unit (FDAU) Software Installation with the use of the_____________________________________________________________________________
 AlliedSignal PCMCIA Interface_____________________________
 A.  General
 (1)  This procedure tells you how to install software in the flight data
 acquisition unit (FDAU) with the use of a personal computer memory
 card international association (PCMCIA) interface.
 (2)  The FDAU must contain these pieces of software:
 (a)  mandatory FDAU software
 (b)  ACMS non-mandatory FDAU software
 (3)  The airplane must be on the ground with the engines shut down before
 you can install software.
 (4)  Make sure you know the correct software part number for the FDAU.
 For the FDAU to be approved installation, the correct software part
 number must be installed.
 (5)  To read about software installation times and data loaders, do this
 task:  On-Airplane Software Installation (AMM 20-15-11/201).
 B.  Reference
 (1)  AMM 20-15-11/201 On-Airplane Software Installation

  ú

 31-31-03
 ALL  ú ú 08.1 Page 211 ú Sep 28/02

A

757
MAINTENANCE MANUAL

 (2)  AMM 24-22-00/201, Electrical Power Control
 C. Access
 (1)  Access Panel
 119BL Main Equipment Center, E3-3

 D. Procedure
 S 862-017
 (1)  
Do this task: Supply Electrical Power (AMM 24-22-00/201).

 S 012-018

 (2)  
Open the PCMCIA door on the front of the FDAU.

 S 202-019

 (3)  
Make sure the PCMCIA slots are empty.

 S 412-020

 (4)
Install the load card into the left slot of the PCMCIA interface.

 (a)  Make sure the IN PROG LED light is ON.
 NOTE: Do not remove the load card from the FDAU while the IN
____ PROG LED is ON. This will cause the FDAU to abort the upload. The upload takes approximately 5 minutes.
 (b)  Make sure the XFER COMP LED light comes on when the load is complete.
 S 022-021
 (5)  
Push the eject button.

 S 022-022

 (6)  
Remove the load card from the PCMCIA interface.

 S 472-023

 (7)  
Move and release the ACMS/DFDAU switch to the applicable position:

 (a)  
DFDAU position to display mandatory software configuration number.

 (b)  
ACMS position to display non-mandatory software configuration number.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 1(119)