S 735-700-002

 (2)  
Do the steps that follow:

 (a)  Open these circuit breakers on the overhead panel, P11, and attach DO-NOT-CLOSE tags: 1) 11J7, FLIGHT RECORDER AC 2) 11J8, FLIGHT RECORDER DC
 S 865-857-002
 (3)  
If you use test equipment other than the hand-held download unit (HHDLU), install the tester to the test connector at the right side panel, P61.

 S 865-858-002

 (4)  
If you use the hand-held download unit (HHDLU), attach the HHDLU to the test connector at the front side of the flight data recorder.

 NOTE: To get access to the FDR, open the lower ceiling panel No. 1
____ above the aft galley (AMM 25-22-02/401). The HHDLU can only be connected to the AlliedSignal flight data recorder (FDR).
 
 GUN 001-008, 010, 101 POST-EO B531006;  ú 31-31-00
 GUN 051, 102-999  ú CONFIG 2 ú 06 Page 509 ú Sep 28/01

A
757
MAINTENANCE MANUAL

 S 865-813-002
 (5)  Remove the DO-NOT-CLOSE tags and close the P11 panel circuit breakers:
 (a) (b)  11J7, FLIGHT RECORDER AC11J8, FLIGHT RECORDER DC
 S 865-892-002
 (6)  Supply electrical power (AMM 24-22-00/201).
 S 865-859-002
 (7)  With the Data Signal Display Unit (DSDU), set the control switches on the tester as follows:
 (a) (b) (c) (d) (e) (f)  Set the power switch to the ON position.Set the INPUT switch to the ARINC INPUT DATA position.Set the SYNC switch to the SYNC B position.Set the DATA PARAMETER/DOCUMENTARY switch to the DATA PARAMETER position.Set the OCTAL DISPLAY switch to the 12 BIT position.Set the SUBFRAME and WORD as specified.
 S 865-860-002
 (8)  With the Teledyne tester (P/N 2222786), set the switches on the tester as follows:
 (a) (b) (c) (d) (e) (f)  Set the POWER switch to the ON position.Set the READOUT switch to the ACTF DATA position.Set the UPDATE switch to the AUTO position.Set the DFDAU/DFDR DATA SELECTOR switch to the DFDAU position.Set the DATA switch to the 12 BIT position.Set the SUBFRAME and WORD as specified.
 S 865-861-002
 (9)  With the Teledyne tester (P/N 2229738), set the switches on the tester as follows:
 (a) (b) (c)  Push the CLR switch two or three times to clear all inputs.Push the DFDR switch and then the ENT switch.Set the SUBFRAME and WORD as specified.
 S 865-862-002

 (10) With the hand-held download unit (HHDLU), do the steps that follow:
 NOTE: These steps are for airplanes equipped with AlliedSignal FDR
____ only.
 (a)  
On the flight recorder control panel (FRCP), set the function switch to the ON position.

 (b)  
Push the red button on top of the HHDLU.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 1(82)