(b)
Push the red button on top of the HHDLU.
(c)
Remove the HHDLU adapter cable from the flight data recorder.
(d)
Install the test plug to the test connector at the flight data recorder.
S 864-055
(2) If you used test equipment other than the HHDLU, do the steps that follow:
(a) Turn the tester off.
GUN 001-008, 010, 101 POST-EO B531006; ú 31-31-09
GUN 051, 102-999 ú ú 12 Page 406 ú Jan 28/02
A
757
MAINTENANCE MANUAL
(b)
Open these P11 panel circuit breakers:
1) 11J7, FLIGHT RECORDER AC
2) 11J8, F5IGHT RECORDER DC
(c)
Disconnect the tester from the right side of the P61 panel.
(d)
Install the test plug to the test connector at the P61 panel.
(e)
Close these P11 panel circuit breakers:
1) 11J7, FLIGHT RECORDER AC
2) 11J8, FLIGHT RECORDER DC
S 864-030
(3) Remove electrical power if it is not necessary (AMM 24-22-00/201).
GUN 001-008, 010, 101 POST-EO B531006; ú 31-31-09
GUN 051, 102-999 ú ú 12 Page 407 ú Sep 28/01
A
757 MAINTENANCE MANUAL
RUDDER PEDAL POSITION TRANSDUCER - REMOVAL/INSTALLATION
_______________________________________________________
1. General_______
A. There are two tasks in this procedure. The first task is the removal of the transducer for the rudder pedal. The second task is the installation of the transducer for the rudder pedal.
B. The transducer is installed on the outboard side of the captain's jack shaft housing.
TASK 31-31-10-004-001
2. Remove the Rudder Pedal Position Transducer (Fig. 401)___________________________________________
A. Equipment
(1) B20003-XX Rig Pin Set (AMM 20-10-24/201)
(a)
Rig Pin R1A
(b)
Rig Pin R1B
(c)
Rig Pin R2
B. References
(1)
AMM 06-41-00/201, Fuselage Access Doors and Panel
(2)
AMM 20-10-23/401, Lockwire
(3)
AMM 20-10-24/201, Rig Pins
C. Access
(1) Location Zone
113 Area forward of NLG wheel well (left)
D. Procedure
S 864-002
(1)
Open these circuit breakers on the overhead circuit breaker panel, P11, and attach DO-NOT-CLOSE tags:
(a)
11J7, FLIGHT RECORDER AC
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 1(149)
