31-31-03
 ALL  ú ú 05 Page 215 ú Jan 28/02

A

757 MAINTENANCE MANUAL
 S 862-043
 (6)  
Make sure the system select switch on the data loader control panel (P61) is set to NORMAL.

 S 022-044

 (7)
Do these steps to do a software configuration check of the FDAU:

 (a)  
AIRPLANES WITH ONE SWITCH ON THE DATA LOADER CONTROL PANEL (P61); Set the system select switch on the data loader control panel to the applicable position. 1) DFDAU position for mandatory FDAU software. 2) ACMS position for non-mandatory FDAU software.

 (b)  
AIRPLANES WITH TWO SWITCHES ON THE DATA LOADER CONTROL PANEL (P61); Do these steps at the data loader control panel: 1) Set the upper switch to SINGLE SYS. 2) Set the system select switch to the applicable position.

 a) DFDAU position to install the mandatory FDAU software. b) ACMS position to install the non-mandatory FDAU software.

 (c)  
If you are not at the MAINT BITE INDEX menu on the CDU, select the line select key adjacent to the INDEX prompt.

 (d)  
If you are at the MAINT BITE INDEX menu, select INIT REF key from the left CDU.

 (e)  
Select the line-select-key adjacent to the INDEX prompt from the left CDU.

 (f)  
Select the line-select-key adjacent to the SEL CONFIG prompt from the left CDU. 1) Make sure the correct software part number shows on the

 CDU.
 S 862-045
 (8) Do this task: Remove Electrical Power (AMM 24-22-00/201).
 TASK 31-31-03-402-096
 8.  ACMS Data Output with the use of the Teledyne FDAU___________________________________________________
 A. General
 (1)  This procedure tells you how to make a copy of the ACMS data using optical or the disk drive on the FDAU.
  ú

 31-31-03
 ALL  ú ú 02 Page 216 ú Sep 28/01

A

757
MAINTENANCE MANUAL

 (2)  You must format the optical or diskette with your applicable instructions before you can make a copy of the ACMS data.
 B. References
 (1)  AMM 24-22-00/201, Supply Electrical Power
 C. Access
 (1)  Location Zone
 (a)  119BL Main Equipment Center E3-3
 D. Procedure
 S 862-097
 (1)  
Do this task: Supply Electrical Power (AMM 24-22-00/201).

 S 012-098

 (2)  
Open the disk drive door on the front of the FDAU.

 (a)  Make sure the disk drive is empty.
 NOTE: If the disk drive is not empty, make sure the disk drive
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 儀表 CHAPTER 31 - INSTRUMENTS 1(122)