R Subtask 05-25-20-010-051
R B. Get Access
R (1) Put an access platform in position.
R (2) Remove the access panels
R (Ref. Fig. 601/TASK 05-25-20-991-001, 602/TASK 05-25-20-991-002)
R 522AB, 522AT, 522BT,
R 522CB, 522EB, 522FB,
R 522HB, 522JB, 522KB,
R 522LB, 522NB, 522QB,
R 522SB, 522UB.
R 622AB, 622AT, 622BT,
R 622CB, 622EB, 622FB,
R 622HB, 622JB, 622KB,
R 622LB, 622NB, 622QB,
R 622SB, 622UB.
R 4. Procedure_________
R Subtask 05-25-20-210-051
R A. Inspection
R (1) Do a general visual inspection of the structure of the outboard fixed
R leading edge.
R (2) Make sure that there are no signs of corrosion, cracks or damage.
R (3) Make sure that all the installations (wiring, ducting, piping) are
R attached correctly.
R 5. Close-up________
R Subtask 05-25-20-410-051
R A. Close Access
R (1) Install the access panels
R 522AB, 522AT, 522BT,
R 522CB, 522EB, 522FB,
R 522HB, 522JB, 522KB,
R 522LB, 522NB, 522QB,
R 522SB, 522UB.
R 622AB, 622AT, 622BT,
R 622CB, 622EB, 622FB,
R 622HB, 622JB, 622KB,
R 622LB, 622NB, 622QB,
R 622SB, 622UB.
R (2) Remove the access platform(s).
R Subtask 05-25-20-866-053
R B. Aircraft Maintenance Configuration
R (1) Fully retract the slats (Ref. TASK 27-80-00-866-005)
R
ZONAL INSPECTION : WING FLAP TRACK FAIRINGS AND WING TIP - INSPECTION/CHECK
___________________________________________________________________________
TASK 05-25-30-200-001
Zonal Inspection of the Flap Track No. 2 and Fairing
WARNING : DO NOT EXTEND THE SLATS AND FLAPS WHEN THE THRUST REVERSER COWLS ARE
_______
DEPLOYED IN THE 45 DEG. POSITION.
1.
Reason for the Job
__________________
Refer to the MPD TASK: ZL-531-01
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 3 m (9 ft. 10 in.)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
27-50-00-866-008 Extension of the Flaps on the Ground
27-50-00-866-009 Retraction of the Flaps on the Ground
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
05-25-30-991-001 Fig. 601
**ON A/C 301-399,
05-25-30-991-001-A Fig. 601A
**ON A/C ALL
3. Job Set-up
__________
Subtask 05-25-30-866-050
A. Aircraft Maintenance Configuration
(1) Fully extend the flaps (Ref. TASK 27-50-00-866-008). Subtask 05-25-30-010-050
B. Get Access
(1) Put an access platform in position.
(2) Remove the access panels: R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 601/TASK 05-25-30-991-001)
**ON A/C 301-399,
(Ref. Fig. 601A/TASK 05-25-30-991-001-A)
**ON A/C ALL
531AT, R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
(Ref. Fig. 601/TASK 05-25-30-991-001)
**ON A/C 301-399,
(Ref. Fig. 601A/TASK 05-25-30-991-001-A)
Access Panels of the Flap Track Fairings
Figure 601/TASK 05-25-30-991-001
R 1EFF : 001-049, 051-099, 101-149, 151-199, 1 05-25-30Page 603 1201-299, 401-499, 1Aug 01/05 1 1 1CES 1
R Access Panels of the Flap Track Fairings
R Figure 601A/TASK 05-25-30-991-001-A
R 1EFF : 301-399, 1 05-25-30 Page 604
1 1 May 01/04
1 1
1CES 1
**ON A/C ALL 中國航空網(wǎng) www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM 時間限制/維護(hù)檢查 3(73)
