pushbutton switch. transmission pushbutton switch come on.
-
Push and release the INT - The reception pushbutton switch moves reception pushbutton switch and fully out and comes on. then turn it to the middle position.
2. On the ACP of the station where
you do the maintenance:
-Set the INT/RAD selector switch
to RAD and hold it in this
position (You can do this
operation on the PTT switch of
1EFF : ALL 1 23-51-00Page 503 1 1 May 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
the side stick controller at the CAPT or F/O station).
-Speak in the boomset microphone.
-Smoothly turn the INT reception pushbutton switch clockwise.
-Turn the INT pushbutton switch to the middle position.
3. At the Captain's and First Officier's stations:
-Smoothly turn the loudspeaker potentiometer clockwise.
4. On the ACP of the station where you do the maintenance:
-Release the INT/RAD selector switch (or the PTT switch on the side stick controller at the CAPT or F/O station)
5. At each crew station, on the ACP:At the Captain's and First Officer'sstations:
-
Make sure that the loudspeakers operate.
At each crew station and at the ground mechanic station:
-
Make sure that the reception in the boomset is correct.
At the station where you do themaintenance:
-
The reception you can hear must change smoothly without interference in the boomset. NOTE: During the test at the CAPT and F/O stations, the volume in the related loudspeakers also changes smoothly without interference.
-
The reception you can hear mustchange smoothly without interference in the loudspeaker.
-
The INT/RAD selector switch goes backto the middle position.
1EFF : ALL 1 23-51-00Page 504 1 1 May 01/01R 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-Set the INT/RAD selector switch to INT.
6. At the ground mechanic station:
-Speak in the boomset
microphone.
7. At each crew station, on the ACP:
-Set the INT/RAD selector switch to the middle position.
-Push the INT transmission
pushbutton switch.
8. On the RMP1:
-Set the ON/OFF selector switch to ON.
-Push the VHF1 pushbutton
switch.
-In the STBY/CRS display window, with the dual selector knob, set the frequency of a station that transmits.
-Start this frequency. To do this, push the transfer pushbutton switch (double arrow) between the two display windows.
9. On the ACP of the station on which you do the maintenance:At each crew station :
-Make sure that the reception in theboomset is correct.
-
The green bars on the INTtransmission pushbutton switch go off.
-
The RMP shows the last frequenciesand the last function used.
-
The green LED on this pushbuttonswitch comes on.
-
The frequency set comes into view inthe left ACTIVE display window.
1EFF : ALL 1 23-51-00Page 505 1 1 Feb 01/98 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-
Push the VHF1 transmission pushbutton switch.
-
Push and release the VHF1 reception pushbutton switch.
-
Set the INT/RAD selector switch to INT and speak in the boomset microphone.
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機(jī)維護(hù)手冊 AMM Communications 通訊2(130)
