R 1EFF : 001-049, 051-099, 101-105, 151-158, 1 23-73-11Page 404 1201-209, 1May 01/05 1 1 1CES 1
Area Call Panel R Figure 401A/TASK 23-73-11-991-001-A
R 1EFF : 106-149, 159-199, 211-299, 401-499, 1 23-73-11Page 405 1 1 Aug 01/05 1 1 1CES 1
Area Call Panel.
R Figure 401B/TASK 23-73-11-991-001-B
R 1EFF : 210-210, 1 23-73-11 Page 406
1 1 Aug 01/05
1 1
1CES 1
Area Call Panel
R Figure 401C/TASK 23-73-11-991-001-C
R 1EFF : 301-399, 1 23-73-11 Page 407
1 1 Aug 01/05
1 1
1CES 1
**ON A/C ALL
Subtask 23-73-11-020-050
A. Removal of the Area Call Panel
(1)
Remove the lens (4) from the area call panel (3).
(2)
Release the spring clips (1), pull and lower the area call panel (3) until you can see the electrical connectors (2).
(3)
Disconnect the electrical connector(2) and remove the area call panel (3).
R 1EFF : ALL 1 23-73-11Page 408 1 1 Aug 01/05 1 1 1CES 1
TASK 23-73-11-400-001
Installation of the Area Call Panel (ACP) 340RH 1. Reason for the Job__________________
Self Explanatory 2. Job Set-up Information______________________ A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 24-41-00-862-002 Energize the Aircraft Electrical Circuits from the External PowerDe-energize the Aircraft Electrical Circuits Supplied from the External Power
**ON A/C 001-049, 051-099, 101-105, 151-158, 201-209,
R 23-73-11-991-001 Fig. 401 **ON A/C 106-149, 159-199, 211-299, 401-499,
R R 23-73-11-991-001-A **ON A/C 210-210, Fig. 401A
R R 23-73-11-991-001-B **ON A/C 301-399, Fig. 401B
R R 23-73-11-991-001-C Fig. 401C
R 1EFF : ALL 1 23-73-11Page 409 1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL
3. Job Set-up
__________
Subtask 23-73-11-860-050
A. Aircraft Maintenance Configuration
(1) Make sure that the aircraft electrical circuits are energized (Ref. TASK 24-41-00-861-002).
(2) Make sure that the stepladder is below the related area call panel. Subtask 23-73-11-865-051
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-299, 301-399,
49VU COM/CIDS/DEU B/ESS 153RH G03 **ON A/C 301-399,
120VU COM / CIDS / DEU B / NORM FWD 193RH M09 **ON A/C 001-049, 051-099, 101-105, 201-299,
121VU COM NAV/CIDS/DEU B/NORM 162RH M07 R **ON A/C 106-149, 151-199, 401-499,
121VU COM NAV/CIDS/DEU B/NORM 162RH M08
1EFF : ALL 1 23-73-11Page 410 1 1 Aug 01/05 1 1 1CES 11EFF : ALL 1 23-73-11Page 411 1 1 Aug 01/05 1 1 1CES 1
**ON A/C 301-399,
Subtask 23-73-11-865-054
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2001VU CIDS/DEU B NORM/ AFT 194RH C08 **ON A/C ALL
4. Procedure_________ **ON A/C 001-049, 051-099, 101-105, 151-158, 201-209,
R (Ref. Fig. 401/TASK 23-73-11-991-001) **ON A/C 106-149, 159-199, 211-299, 401-499,
R R (Ref. Fig. 401A/TASK 23-73-11-991-001-A) **ON A/C 210-210,
R R (Ref. Fig. 401B/TASK 23-73-11-991-001-B) **ON A/C 301-399,
R R (Ref. Fig. 401C/TASK 23-73-11-991-001-C)
INTENTIONALLY BLANK
R 1 1
23-73-11Page 412
1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL
Subtask 23-73-11-420-050
A. Installation of the Area Call Panel
(1)
Clean the component interface and/or the adjacent area.
(2)
Do an inspection of the component interface and/or the adjacent area.
(3)
Connect the electrical connectors (2) to the area call panel (3).
(4)
Install the area call panel (3). Make sure that you hear an audible click when the area call panel (3) locks in position.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM Communications 通訊4(89)
