C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-11-28-650-003 Pressure Refuel with Automatic Control 28-10-00-910-001 Safety Procedures When You Do Work in a Fuel Tank 28-11-00-790-002 Leak Test with Fuel of the Wing-Tank Outer and Inner
Cells
28-11-00-790-008 Leak Test with Fuel of the Wing Tank
28-25-00-650-001 Pressure Defuel
28-25-00-869-001 Fuel Transfer
32-12-00-010-001 Open the Main Gear Doors for Access
32-12-00-410-001 Close the Main Gear Doors after Access
3. Job Set-up
__________
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 28-11-00-941-080
A. Safety Precautions
WARNING : OBEY THE SAFETY PROCEDURES WHEN YOU DO WORK IN A FUEL TANK.
_______
(1)
If you want to test the RIB1 you must do the Leak Test with Fuel of the Wing-Tank Outer and Inner Cells (Ref. TASK 28-11-00-790-002).
(2)
You must obey the fuel safety procedures (Ref. TASK 28-10-00-910-001) when you do work in a fuel tank.
(3)
Put warning notices in position to tell persons not to operate the flight controls and the MLG doors.
1EFF : ALL 1 28-11-00Page 528 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 28-11-00Page 529 1 1 May 01/04 1 1 1CES 1 **ON A/C ALL
(4) Make sure that the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
(98D27803500001) is on the flap/slat control lever.
(5) Put the safety barriers in position.
Subtask 28-11-00-650-105
B. Fuel Configuration
(1) Fully refuel the center tank (Ref. TASK 12-11-28-650-003).
R **ON A/C 301-399,
R Subtask 28-11-00-941-080-A
R A. Safety Precautions
R WARNING : OBEY THE FUEL SAFETY PROCEDURES._______
R (1) If you want to test the RIB1 you must do the Leak Test with Fuel of
R the Wing Tank (Ref. TASK 28-11-00-790-008).
R (2) You must obey the fuel safety procedures (Ref. TASK 28-10-00-910-001)
R when you do work in a fuel tank.
R (3) Put warning notices in position to tell persons not to operate the
R flight controls and the MLG doors.
R (4) Make sure that the TOOL-ZERO LOCKING, FLAP SLAT CTL LEVER
R (98D27803500001) is on the flap/slat control lever.
R (5) Put the safety barriers in position.
R Subtask 28-11-00-650-105-A
R B. Fuel Configuration
R (1) Fully refuel the aircraft (Ref. TASK 12-11-28-650-003).
Subtask 28-11-00-865-075
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
-------------------------------------------------------------------------------
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
121VU FUEL/CTR TK/PUMP2 SPLY 30QA P26
121VU FUEL/CTR TK/PUMP1 SPLY 29QA P23
**ON A/C ALL
121VU FUEL/L WING TK/PUMP2 SPLY 7QA N26 121VU FUEL/L WING TK/PUMP1 SPLY 1QA N23 121VU FUEL/R WING TK/PUMP2 SPLY 8QA Q26 121VU FUEL/R WING TK/PUMP1 SPLY 2QA Q23
**ON A/C 301-399,
121VU FUEL/CTR TK/L&R XFR/CTL & IND 2QL R26
121VU FUEL/CTR TK/L&R XFR/CTL & IND 1QL R25
**ON A/C ALL
123VU L WING TK/PUMP 1/STBY SPLY 11QA AD12
123VU R WING TK/PUMP 1/STBY SPLY 12QA AE12
Subtask 28-11-00-010-058
D. Get Access
(1) Put the access platform in position:
- on the left wing, below zones 541
- on the right wing, below zones 641.
1EFF : ALL 1 28-11-00Page 530 1 1 Aug 01/05 1 1 1CES 1
(2)
Remove the applicable leading-edge access panel:
- on the left wing remove 521AB
- on the right wing remove 621AB.
(3)
Open the main gear doors (Ref. TASK 32-12-00-010-001) to get access to the rear of the center tank.
(4)
Make sure that the GROUND LOCK SLEEVE (460005835) is on the applicable main gear door actuator.
(5)
For access to the front of the center tank remove the access panels 132PW, 131NW, 131PW.
Subtask 28-11-00-680-050
E. Drain the Fuel
(1) Drain all remaining fuel from the leak monitor 500QM with the PURGING TOOL (97A28002117002) and a container.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油1(112)
