(3)  
Two VOR/ILS - NAV transfer relays:

 (a)  
VOR/ILS-NAV transfer relay No. 1 (R304)

 (b)  
VOR/ILS-NAV transfer relay No. 2 (R305)

 TASK 34-31-71-004-061
 2.  Antenna Transfer Relay Removal______________________________
 A.  General
 (1)  The antenna transfer relays are installed on shelf 4 of the electronics equipment rack (E3).
 B.  References
 (1)  AMM 34-31-91/401, RF Attenuator
 C.  Access
 (1)  
Location Zone
 205 Electronics Compartment

 (2)  
Access Panel
 1201L Electronic Equipment Access Door

 D.  Procedure
 S 864-136
 (1)  For the ILS transfer relay No. 1, open this circuit breaker and attach a DO-NOT-CLOSE tag:
 (a)  P18 Load Control Center - Left
 1) VOR/LOC-1

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 34-31-71
 ú ú 06 Page 401 ú Nov 12/99

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 864-138
 (2)  For the ILS transfer relay No. 2, open this circuit breaker and attach a DO-NOT-CLOSE tag:
 (a)  P6 Load Control Center - Right
 1) VOR/LOC-2

 S 024-068
 (3)  Remove the antenna transfer relay:
 (a)  
If the RF attenuator is installed, do these steps: 1) Disconnect the coaxial cable from the RF attenuator. 2) Remove the RF attenuator from the relay (Ref 34-31-91/401).

 (b)  
Disconnect the coaxial cables and electrical cables from the relay.

 (c)  
Remove the screws that attach the relay to the shelf.

 (d)  
Remove the antenna transfer relay from the shelf.

 TASK 34-31-71-404-069
 3. Antenna Transfer Relay Installation
___________________________________
 A. General
 (1)  The antenna transfer relays are installed on shelf 4 of the electronics equipment rack (E3).
 B. References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 34-31-00/501, VOR/ILS Navigation System

 (3)  
AMM 34-31-91/401, RF Attenuator

 C. Access
 (1)  
Location Zone
 205 Electronic Compartment

 (2)  
Access Panel
 1201L Electronic Equipment Access Door

 D. Procedure
 S 864-144
 (1)  For the ILS transfer relay No. 1: Open this circuit breaker and attach a DO-NOT-CLOSE tag:
 (a)  P18 Load Control Center - Left
 1) VOR/LOC-1

 S 864-146
 (2)  For the ILS transfer relay No. 2: Open this circuit breaker and attach a DO-NOT-CLOSE tag:
 (a)  P6 Load Control Center - Right
 1) VOR/LOC-2

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 34-31-71

 ú ú 06 Page 402 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 024-131
 (3)  Install the antenna transfer relay:
 (a)  
Align the relay to the holes in the shelf.

 (b)  
Install the screws to attach the relay to the shelf.

 (c)  
If it is necessary, install the RF attenuator on the relay (AMM 34-31-91/401).

 (d)  
Connect the coaxial cables and electrical cables to the relay and tighten with your hand.

 S 864-152
 (4)  For the ILS transfer relay No. 1, remove ths DO-NOT-CLOSE tag and close this circuit breaker:
 (a)  P18 Load Control Center - Left
 1) VOR/LOC-1

 S 864-154
 (5)  For the ILS transfer relay No. 2, remove the DO-NOT-CLOSE tag and close this circuit breaker:
 (a)  P6 Load Control Center - Right
 1) VOR/LOC-2

 S 714-120
 (6)  
Do the ILS Antenna Transfer Relay Test part of the VOR/ILS System Test (Ref 34-31-00/501).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 3(28)