34-41-01
ALL ú ú 02B Page 15 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
TARGET ALERT WINDOW TARGET ALERT FIELD A AZIM 0 200100 300 TEST 50 25 10 RANGE GAIN OFF ON OFF STBY WX CYC PRE 30` SET` INT MAP 1 2 3 10 5 0 5 10 TILT 30` FRZ F +15 -15 GREEN YELLOW RED
NOISE BAND 60` 100 60`
SEC 80 TGT
RANGE MARKS SCAN S TEST 20 40 60 T ALRT
WEATHER MODE
TARGET ALERT WINDOW 200100 300 TEST RANGE GAIN OFF OFF STBY CYC PRE 30` SET` WX 0 ON 50 25 10 INT MAP 1 2 3 TILT 30` 10 5 0 5 10 +15 -15 CYAN YELLOW MAGENTA
AZIM FRZ
NOISE BAND A 100 F
60` 60`
SEC 80 TGT
RANGE MARKS SCAN S TEST 20 40 60 ALRT T
MAP MODE
Weather Radar Test Modes
Figure 5
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-41-01
ALL ú ú 02B Page 16 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
K09229
(f)
A
737-300/400/500MAINTENANCE MANUAL
WARNING:_______ THE TARGET ALERT FUNCTION IS NOT TO BE USED AS THE
PRIME SOURCE FOR STORM, TERRAIN, OR OTHER OBJECT
AVOIDANCE.
11) TGT ALRT (target alert) pushbutton - When pressed, the target alert mode is activated and is indicated by the letter T in a red rectangle on the upper left corner of the indicator display. If a contourable target (red indication at a preset gain) occurs in the target alert window 75 to 150 NM range and 15 degrees left or right of dead ahead, a TGT alert label (Fig. 4) in a red rectangle will be flashed on and off at 1/2 second intervals on the indicator display.
12) INT (intensity) control knob - Varies the intensity of video on the display.
13) GAIN control knob - In PRESET (detented) position, sets the level of the IF and video amplifiers to a level based on the receiver noise level. This level is automatically utilized when CYC and TEST modes are selected. The variable gain manual (out-of-detent) position is operable only in WX and MAP modes. Receiver noise on the display should increase when the GAIN control is rotated clockwise.
14) AZIM (azimuth marker) pushbutton - When activated, displays
azimuth strobe lines 30 degrees apart.The indicator also contains circuitry for generating alphanumerics used to display information on the CRT screen. The different types of indications are as follows: 1) Mode field - Appears on lower left corner of display.
Selected mode is displayed as STBY, WX, or MAP. PUSH is displayed when an "all buttons out" condition exists. WAIT is displayed if indicator is synchronizing with antenna or during warm-up. TEST is displayed when RANGE selector is in test position, but is overridden by STBY, WAIT, or PUSH modes. ANT is displayed as a blinking word when the antenna is not sweeping because of an antenna failure.
2) Sub-mode field - Appears just above mode field in lower left corner of display. FRZ is displayed as a blinking word when freeze control is activated, but is blanked out in STBY, WAIT, or PUSH mode. VAR is displayed if GAIN control is out of PRESET position. VAR is overridden by FRZ.
3) Target field - Appears in upper left corner of display when TGT ALRT is selected. The letter(s) T or TGT will be displayed in a red rectangle.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
34-41-01
ALL ú ú 02B Page 17 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
4) Auxiliary field - Displays color bar legend and level numbers: 1, 2, and 3 on upper right corner. In weather mode, colors are green, yellow, and red; and in map mode, colors are cyan, yellow, and magenta.
5) Range mark identifiers - Five labelled range mark identifiers are displayed in cyan for WX and green for MAP.
D. System shutdown procedures
(1) Perform in the sequence.
(a)
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 3(53)
