54-31-01
 ALL  ú ú B01 Page 405 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (d) Turn the screwdriver 90 degrees in the clockwise direction.
 NOTE: Make sure the indicator grooves are at an angle of
____ 90 degrees from the edge of the door.
 (e)  If the latches on the panels are worn and need to be replaced do these steps: 1) Remove the latch nut from the screw, then remove the screw
 and indicator from the panel. 2) Remove the anchor block and shimplate on the panel that is attached by rivets.
 3)  Install a new shimplate and anchor block with BMS 10-79 TYPE III and rivets. a) Make sure the end of rivet fills the countersink for
 the anchor block a minimum of 80 percent and is flush to +0.01 inch. 4) Install new screw, latchnut and indicator.
 S 214-007-B00
 (3)  
Make sure the panels are smooth (AMM 54-10-00/501).

 S 444-008-B00

 (4)  
Do the activation procedure for the thrust reverser (AMM 78-31-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-31-01
 ALL  ú ú B01 Page 406 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 FORWARD FAIRING - REMOVAL/INSTALLATION
______________________________________
 1.  General_______
 A.  There are two tasks in this procedure:
 (1)  
The first task removes the forward fairings

 (2)  
The second task installs the forward fairings.

 B.  There are three forward fairings:
 (1)  
The first fairing, the forward fairing, is above the fan cowl panels at the front of the strut.

 (2)  
The second fairing, the mid-strut fairing, consists of a left and right half that covers the mid section.

 (3)  
The third fairing, the forward leading edge fairing, is at the top rear of the strut, above the wing leading edge.

 C.  To get the access to the forward strut mount fitting, it is necessary to remove the forward fairing.
 D.  To get the access to the control cables of the engine you must remove the forward fairing, the mid-strut fairing, and the wing leading edge fairing.
 TASK 54-32-01-004-001-B00
 2.  Remove the Forward Fairings___________________________
 A.  References
 (1)  
AMM 27-81-00/201, Leading Edge Slats

 (2)  
AMM 78-31-00/201, Thrust Reverser System

 B.  Access
 (1)  Location Zones
 500 Left Nacelle
 600 Right Nacelle

 C.  Prepare for the Removal of the Fairings.
 S 044-014-B00
 WARNING: DO THE DEACTIVATION PROCEDURE FOR THE THRUST REVERSER FOR
_______ GROUND MAINTENANCE TO PREVENT THE OPERATION OF THE THRUST REVERSER. ACCIDENTAL OPERATION OF THE THRUST REVERSER CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
 (1)  Do the deactivation procedure for the thrust reverser for ground maintenance (AMM 78-31-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-32-01
 ALL  ú ú B02 Page 401 ú Jul 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 044-015-B00
 WARNING: OBEY THE PRECAUTIONS IN THE PROCEDURE WHEN YOU DO THE
_______ DEACTIVATION PROCEDURE FOR THE LEADING EDGE SLATS. IF YOU DO NOT OBEY THE PRECAUTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (2)  Do the deactivation procedure for the leading edge slats
 (AMM 27-81-00/201).

 D. Procedure
 S 024-009-B00
 (1)  Do these steps to remove the forward fairing (Fig. 401):
 (a)  
Remove the screws at 28 locations that attach the forward fairing to the strut.

 (b)  
Remove the clips that attach to the top of the fairing and disengage the fairing.

 (c)  
Remove the clips from the aft edge of the fairing.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 NACELLES/PYLONS(32)