S 494-040-C00

 (3)  
Put the fan cowl hinge hangars on the roll pins at the forward middle and aft hinge locations.

 S 824-041-C00

 (4)  
Move the fan cowl panel to the open position and adjust it to align the holes of the middle hinges.

 S 434-042-C00

 (5)  
Lubricate the shanks with grease and install them into the holes of the middle hinges.

 NOTE: Do not lubricate the bolt threads with grease.
____
 S 434-043-C00
 (6)  Install the washers and nuts.
 (a)  Tighten the nuts with your hand.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-11-02
 ALL  ú ú C02 Page 413 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 434-044-C00
 (7) Align the holes of the forward and aft hinges and install the bolts.
 NOTE: You can apply a maximum preload of 30 pounds (135 N) to the
____ cowl at the hinge locations when you align the forward and aft hinges.
 Do not lubricate the bolt threads with grease.
 S 434-045-C00
 (8)
Install the washers and nuts.

 (a)
Tighten the nuts with your hand.

 S 434-046-C00
 (9)
Tighten the nuts at all of the hinge locations.

 S 494-047-C00

 (10)
 Hold the fan cowl panel with the hold-open rod.

 S 094-048-C00

 (11)
 Loosen the fishpole hoist cable and remove the fan cowl sling from the fan cowl panel.

 S 824-049-C00

 (12)
 Do the adjustment procedure for the fan cowl panel latch
 (AMM 71-11-03/501).

 S 094-050-C00

 (13)
 Remove the fan cowl sling from the fishpole hoist.

 S 094-051-C00

 (14)
 Remove the fishpole hoist from the boom trolley.

 S 094-052-C00

 (15)
 Remove the boom assembly from the engine strut attach fittings.

 S 094-053-C00

 (16)
 Remove the engine strut attach fittings from the forward strut mount fittings.

 S 424-054-C00

 (17)
 Install the forward fairing (AMM 54-32-01/401).

 G.
Put the airplane back to its usual condition.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-11-02
 ALL  ú ú C02 Page 414 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 424-075-C00
 CAUTION:_______INSTALL THE VCD ONLY ON THE INBOARD FAN COWL PANEL. THE INCORRECT INSTALLATION OF THE FAN COWL VCD CAN CAUSE UNSATISFACTORY AIRPLANE PERFORMANCE.
 (1)  
If you replaced the inboard fan cowl panel, install the VCD on the replacement panel (AMM 71-11-08/401).

 S 214-058-C00

 (2)  
If you replaced the outboard fan cowl panel,make sure the protruding head screws are installed in the fan cowl panel fastener holes.

 S 434-059-C00

 (3)  
If the protruding head screws are not installed in the fastener holes, do these steps:

 (a)  
Open the fan cowl panel (AMM 71-11-02/201).

 (b)  
Apply sealant (BMS 5-95) to the top mating surface of the washers and the bottom of the screw heads.

 (c)  
Install the screws, washers, and collars (16 locations each).

 (d)  
Close the fan cowl panel (Ref 71-11-02/201).

 (e)  
Make sure the manual starter guide opening is aligned with the manual starter value.

 S 444-060-C00
 (4)  Do the activation for the leading edge flaps as follows or, if only leading edge devices were deactivated (AMM 27-81-00/201):
 (a)  
Remove the DO-NOT-CLOSE tag and close this circuit breakers: 1) P6-2 Circuit Breaker Panel a) FLAP 2) P6-11 Circuit Breaker Panel a) STBY HYD PUMP NORMAL
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 動力裝置 POWER PLANT 2(131)