27-62-03
 ALL  ú ú 03 Page 206 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (h)  Connect the actuator input control rod to the idler crank with the bolt, washer, nut and spacer.
 NOTE: If necessary, compress the brake spring and rotate the
____ arc to move the rod.
 (i)  
Connect the manual input control rod to the idler crank with the bolt, washer, nut and spacer.

 (j)  
Put the tension spring on the cam follower lever.

 S 432-032
 (4)  
Attach the cables SBA and SBB to the mechanism.

 S 832-006

 (5)  
Do this task: "Speed Brake Control System Adjustment" (AMM 27-62-00/501).

 S 712-033

 (6)  
Do this task: "Speed Brake Mechanism Operational Test"

 S 412-045

 (7)  
Install the ceiling lining panel that you removed
 (AMM 25-59-01/401).

 TASK 27-62-03-712-007
 4. Speed Brake Mechanism Operational Test
______________________________________
 A. Standard Tools and Equipment
 (1)  
Spring scale 0 to 50-pound (0-222 Nm) capacity

 B.
References

 (1)  
AMM 27-62-10/401, Automatic Speed Brake Arm Switch

 (2)  
AMM 29-11-00/201, Main Hydraulic Supply System

 (3)  
AMM 31-61-00/201, Integrated Display System

 (4)  
AMM 32-00-30/201, Landing Gear Door Locks

 C.
Access

 (1)  
Location Zone
 221, 222 Control Cabin

 D.
Procedure

 (1)  
Make sure the landing gear ground locks are installed.

 S 862-035
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-62-03
 ALL  ú ú 07 Page 207 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 492-036 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO INSTALL
_______
 THE DOOR LOCKS IN THE LANDING GEAR DOORS.  THE DOORS CAN CLOSE
 QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT. THIS
 (2)  Do this task: "Wing Landing Gear Door Lock Installation" (AMM 32-00-30/201).
 S 862-010
 (3)  Do this task: "Obtain Airplane System Information" (AMM 31-61-00/201).
 S 712-042
 (4)  Do this task:  "Aural Warning System Test" (AMM 31-52-00/501).
 S 862-011
 (5)  Show the Thrust Resolver Angle (TRA) on the EICAS.
 S 712-012
 (6)  Do the test of the manual control of the speed brake lever. (a) Put the speed brake lever in the DOWN position. (b) Make sure the speed brake quadrant at the sequence mechanism touches the quadrant stop.
 S 862-014
 (7)  Do this task:  "Pressurize Hydraulic System" (AMM 29-11-00/201).
 S 712-013
 (8)  Use the spring scale to do the test of the friction in the speed brake system. (a) Lift the speed brake lever out of the DOWN detent. (b) Put the spring scale at the end of the speed brake lever. (c) Measure the force necessary to move the speed brake lever in the up direction. 1) Make sure the force necessary to move from the DOWN position to the FLIGHT position is not more than 30 pounds (133 Nm). 2) Make sure the force necessary to move from the FLIGHT position to the UP position is not more than 30 pounds (133 Nm). (d) Measure the force necessary to move the speed brake lever in the down direction.
 1) 2)  Make sure the force necessary to move from the UP position to the FLIGHT position is not more than 25 pounds (111 Nm).Make sure the force necessary to move from the FLIGHT position to the DOWN position is not more than 25 pounds. (111 Nm)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-62-03
 ALL  ú ú 04 Page 208 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 7(4)