B.
Access
(1)
Location Zone
211 Forward Passenger Cabin, LH
C.
Prepare for the Removal
S 864-002
(1)
Open the circuit breakers as follows for the steering system of the nose gear :
(a)
P7 Overhead Circuit Breaker Panel
1) 7G25 NOSE GR STEERING PRI
2) 7G26 NOSE GR STEERING ALT.
S 014-005
(2)
Remove the second center ceiling panel, aft in Zone A.
D.
Remove the Interconnect Actuator (Fig. 401)
S 024-006
(1)
Remove the interconnect actuator No. 1.
(a)
Disconnect the electrical connector X503 from the actuator No. 1 and seal the plug and the receptacle with a cap.
(b)
Remove the bolts (1) and (2) which attach the actuator to the interconnect lever and the bellcrank.
(c)
Remove the actuator from the airplane.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-51-07
ALL ú ú 01 Page 401 ú Oct 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL
PEDAL
STEERING
MICRO-
SWITCH
4. BOLT
3. BOLT
RUDDER PEDAL
INTERCONNECT
ACTUATOR NO. 2
LEVER
BELLCRANK
RUDDER PEDAL
INTERCONNECT
ACTUATOR NO. 1
2. BOLT 1. BOLT
INBD FWD
Nose Gear Rudder Pedal Steering Interconnect Actuator Installation
Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-51-07
ALL ú ú 01 Page 402 ú Jun 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
S 024-007
(2)
Remove the interconnect actuator No. 2.
(a)
Disconnect the electrical connector H87 from the actuator No. 2 and seal the plug and the receptacle with a cap.
(b)
Remove the bolts (3) and (4) which attach the actuator to the actuator support and the bellcrank.
(c)
Remove the actuator from the airplane.
TASK 32-51-07-404-008
3. Install the Nose Gear Rudder Pedal Steering Interconnect Actuator__________________________________________________________________
A. Special Tools and Equipment
(1)
A27092-84 - Actuator/Deactuator Set - Proximity Sensors
(2)
G12001 - Rigging Pin - NS-3, 0.311 (0.000/-0.002)-inch diameter by 6 inches long
B.
References
(1)
AMM 24-22-00/201, Manual Control
(2)
AMM 32-51-00/501, Nose Wheel Steering System
(3)
IPC 32-51-61 Fig. 1
C.
Access
(1)
Location Zone
211 Forward Passenger Cabin, RH
D.
Install the Interconnect Actuator (Fig. 401)
S 494-009
(1)
Install the rigging pin NS-3 (AMM 32-51-00/501).
S 424-010
(2)
Install the interconnect actuator No. 1.
(a)
With the actuator in the retracted position (5.60 [| 0.020] inches between the mounting holes) and the plug receptacle pointed down, install the rod end through the slot in the actuator lever.
(b)
Install the bolt (1) and the bushing with its head up and attach with the nut and the washer.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-51-07
ALL ú ú 02 Page 403 ú Feb 18/02
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機(jī)維護(hù)手冊 起落架 LANDING GEAR 8(38)
