32-51-00
 ALL  ú ú 01 Page 519 ú Jun 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 085-070
 (11)
 Remove the actuator from the primary nose gear squat sensor (S800) only.

 S 745-071

 (12)
 Do a bite test of the nose gear steering with the alternate squat sensor activated and the primary sensor deactivated.

 (a)  
Make sure that the status of bit 21 on the CDU display of label 270 on page 1 is a 0 (NG COMPRESSED).

 (b)  
Make sure that the status of bit 21 on the CDU display of label 272 on page 2 is a 1 (NG NOT COMPRESSED).

 S 715-072
 (13)
 Do a test of the air/ground sensing and pedal steering on the EICAS.

 (a)  
Make sure that the EICAS message NOSE AIR/GROUND DISAGREE comes into view on the lower EICAS CRT.

 (b)  
Move the EIU select switch to the C position.

 (c)  
Make sure that NOSE AIR/GROUND DISAGREE comes into view on the EICAS.

 (d)  
Move the EIU select switch to the "R" position.

 (e)  
Make sure that NOSE AIR/GROUND DISAGREE comes into view on the EICAS.

 (f)  
Move the EIU select switch to L.

 (g)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 1 (one electrical interconnect actuator is INOP).

 (h)  
Move the EIU select switch to C.

 (i)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 1 (one electrical interconnect actuator is INOP).

 (j)  
Move the EIU select switch to R.

 (k)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 1 (one electrical interconnect actuator is INOP).

 (l)  
Move the EIU select switch to AUTO.

 S 715-073
 (14)
 Do a check of the NG steering system with the deactivated primary squat sensor.

 (a)  
Push the captain's left rudder pedal fully forward and hold in that position. 1) Make sure that the steering collar at the nose gear turns 6

 to 8 degrees from the neutral position.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-51-00
 ALL  ú ú 01 Page 520 ú Jun 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 2) Release the captain's left rudder pedal and permit it to go to the neutral position. 3) Make sure that rig pin R-3 fits loosely in the rudder quadrant. 4) Make sure that the steering collar goes to the neutral position |2.0 degrees.
 S 715-074
 (15)
 Repeat the above check but push the captain's right rudder pedal.

 (a)  
Make sure the results are the same.

 S 495-075
 (16)
 Actuate the primary nose gear squat sensor (S800).

 S 715-076

 (17)
 Make sure that NOSE AIR/GROUND DISAGREE is not shown on the EICAS.

 S 095-078

 (18)
 Remove the actuator from the alternate nose gear squat sensor (S801) only.

 S 715-079

 (19)
 Make sure that NOSE AIR/GROUND DISAGREE comes into view on the EICAS.

 S 745-080

 (20)
 Do a bite test of the nose gear steering with the primary squat sensor activated and the alternate squat sensor deactivated.

 (a)  
Make sure that the status of bit 21 on the CDU display of label 272 on page 2 is a 0 (NG COMPRESSED).

 (b)  
Make sure that the status of bit 21 on the CDU display of label 270 on page 1 is a 1 (NG NOT COMPRESSED).

 (c)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 1 (one electrical interconnect actuator is INOP).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-51-00
 ALL  ú ú 01 Page 521 ú Jun 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機(jī)維護(hù)手冊(cè) 起落架 LANDING GEAR 8(5)