S 225-817
 (16) Measure the angle of travel of the control column from the neutral position to the point where the stabilizer stops. The angle of travel should be 3.5 to 4.0 degrees.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 02 Page 566 ú Jan 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 865-818
 (17)
 Let the control column go to the neutral position.

 S 865-819

 (18)
 Hold the stabilizer-trim control-wheel-switches down (airplane nose up) until the stabilizer stops.

 S 865-820

 (19)
 Move the captain's stabilizer-trim control-wheel-switches up (airplane nose down).

 (a)
Make sure the stabilizer moves.

 S 865-821
 (20) While the switches are held up, slowly pull the control column aft until the stabilizer stops.
 NOTE: Do this step while the stabilizer indicated position is
____
 between 5.0 and 15.5 units of trim.

 S 225-822
 (21)
 Measure the angle of travel of the control column from the neutral position to the point where the stabilizer stops. The angle of travel should be 2.2 to 2.7 degrees.

 S 865-823

 (22)
 Release the stabilizer-trim control-wheel-switches.

 (23)
 Let the control column go to the neutral position.

 (24)
 Put the RIGHT STAB TRIM SHUTOFF switch to CUTOUT.

 (25)
 Put the CENTER STAB TRIM SHUTOFF switch to NORM.

 S 865-824
 S 865-825
 S 865-826
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 02 Page 567 ú Jan 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 S 865-827
 (26)
 Move the captain's stabilizer-trim control-wheel-switches up (airplane nose down).

 (a)
Make sure the stabilizer moves.

 S 865-828
 (27) While the switches are held up, slowly pull the control column aft until the stabilizer stops.
 NOTE: Do this step while the stabilizer indicated position is
____
 between 5.0 and 15.5 units of trim.

 S 225-829
 (28)
 Measure the angle of travel of the control column from the neutral position to the point where the stabilizer stops. The angle of travel should be 2.2 to 2.7 degrees.

 S 865-830

 (29)
 Let the control column go to the neutral position.

 S 865-831

 (30)
 Hold the stabilizer-trim control-wheel-switches up (airplane nose down) until the stabilizer stops.

 S 865-832

 (31)
 Release the stabilizer-trim control-wheel-switches.

 S 095-833

 (32)
 Remove the elastic cord from around the lower ends of first officer's switch actuating arms. This will allow the first officer's stabilizer-trim cutoff switches to operate.

 S 865-893

 (33)
 Do the steps that follow to prevent the operation of the captain's stabilizer-trim cutoff switches:

 (a)
Open the forward compartment access door, 113AL (Ref 06-41-00).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-41-00
 ALL  ú ú 02 Page 568 ú Jan 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

757
MAINTENANCE MANUAL

 (b)  
Install an elastic cord (or other applicable device) around the lower ends of each set of opposite switch actuating arms.

 (c)  
Add sufficient tension to make a space between the switch-actuating-arms and the switch levers. The switch-actuating-arm cam rollers should be away from the control column cam-surface.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 4(32)