NOTE: EnsureproperhightemperatureO-ringis usedby referringto PartsCatalog.

(b)
Screwswitchintoreceptacle.

(c)
Connectwiresto switch.

EFFECTIVITY: 040-999
PAGE5
21-40-00
Jan10/90

PIPER AIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCE MANUAL

A. Heatingand Cooling (continued)
NOTE: This unit is located in the nose section,right side, between stations 57.00 and 25.60.
GROUND AIR FAN (SERVICE-500 HR)
ER SEPARATOR
COALESCER (SERVICE-500HR)
UNITREFRIGERATION

LEGEND OVERPRESS ELECTRICAL INLET
SWITCH OPEN = 40 ± 3 psig

REFRIGERATION
UNIT BOUNDARY
Environmental
Control System Figure401
EFFECTIVITY:
040-999

PAGE
Jan 10/90 21-40-00
PIPERAIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCEMANUAL

A. Temperature Control
1. Removalof Duct Temperature Sensor
(a)
Gain access to duct temperature sensor under the floor on right hand side of fuselage, immediately aft of F.S. 57.00 forward pressure bulkhead.

(b)
Remove four screws securing sensor in position.

(c)
Remove sensor with gasket.

2. Installation of Duct Temperature Sensor
(a) Install new sensor and gasket. Secure with four screws.
3. Removal of Cabin Temperature Sensor and Controller
(a)
Gain access to cabin temperature sensor and controller. Remove screws and washers to secure unit in position. Pull unit out so electrical connector can be disconnected.

(b)
Remove cabin temperature and controller.

4. Installationof Cabin Temperature Sensor and Controller
(a)
Install new sensor and connect electrical connector.

(b)
Secure unit with washers and screws.

EFFECTIVITY: 040-999
21-60-00 Jan 10/90

PIPER AIRCRAFT
PA-42-720(Advanced Trainer)
MAINTENANCEMANUAL

A. Moisture/AirContaminantControl
1. Removalof Water Separator
(a)
Disconnectwater line, inlet, and outlet air connections from water separator.

(b)
Removeclampssecuringwater separator.

(c)
Removewater separator.

2. Installationof Water Separator
(a)
Secure water separator to hoses with clamps. Torque 30 to 35 inch-pounds.

(b)
Connect water line to water separator.

3. Cleaning,Inspectionand Repairs of Water Separator
The coalescer cloth must be cleaned or replaced at 500 flight hours or less, except when operated in abnormally dustyor contaminating conditions.
(a)
Remove band and cover from water separator.

(b)
Remove coalescer cloth from inside water separator.

(c)
Wash coalescer cloth with warm water and mild detergent; rinse with clean water.

CAUTION: DO NOT WRING COALESCER CLOTH.

(d)
Replace coalescer cloth on inner housing with nap inside against the screen and rubber bands flatand firmly in place.

(e)
Installcover and band on water separator.

EFFECTIVITY:

21-70-00 PAGE1

Jan10/90

PIPER AIRCRAFT PA-42-720 (Advanced Trainer) MAINTENANCE MANUAL 
CHAPTER 23 
LIST OF EFFECTIVE PAGES 
CHAPTER SECTION  PAGE  DATE  CHAPTER SECTION  PAGE  DATE 
23-EFFECTIVITY 23-CONTENTS 23-60-00 23-70-00 23-70-00  1 1 1 1 2  Apr 15/91 Apr 15/91 Jan 10/90 Jan 10/90 Jan 10/90 

LISTOF EFFECTIVEPAGESApr

PIPER AIRCRAFT PA-42-720 (Advanced Trainer) MAINTENANCE MANUAL 
CHAPTER 23- COMMUNICATIONS 
TABLE OF CONTENTS 
SUBJECT  CHAPTER  PAGE 
I  Static Discharging Inspection and Testing  23-60-00  1 1 
Audio & VideoMonitoring Cockpit Voice Recorder (CVR) Removalof CVR Unit Installationof CVR Unit Testing  23-70-00  1 1 1 1 1 

EFFECTIVITY:
040-999
CONTENTSPAGE1

PIPERAIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCEMANUAL

A. Static Discharging
1. Inspection and Testing
Static discharging wicks must be inspected at each annual inspection for the following:
(a)
Generalappearanceand physical condition.

(b)
Securityof attachment to airframe.

(c)
Dischargepoints visible.

(d)
Resistance(1.0 to 100 megohms, 500 to 1,000 volt megohmmeter).

(e)
Base resistance to airframe (100 milliohms maximum).

EFFECTIVITY:
040-999
23-60-00PAGE1
23-60-00 Jan 10/90
PIPERAIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCEMANUAL

A. Audio & Video Monitoring
1. Cockpit Voice Recorder (CVR)
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：夏延飛機維護手冊 Cheyenne IIIA PA-42-720 AMM 1(68)