(b)
Refer to Chart 2 for Overhaul and Replacement Schedule.
(c)
The safe life limit of propeller blades is unlimited.
NOTE: Refer to the LIMITATIONS section in the Pilot’s Operating Handbook for a detailed delineation of the flight limitations of the airplane.
CHART 1 STRUCTURAL INSPECTION AND REPLACEMENT
Component Life Limit (Flight Hours) Inspection Interval (Flight Hours) Effectivity Code
Wing and Associated Structure 25,000 7,800 and 10,000 C
Cabin and Pressurized Structure 15,000 34,333 36,848 12,300 and 13,900 28,044 and 31,692 30,258 and 34,184 B D A
Empennage and Associated Structure 25,000 11,600 and 13,300 C
CHART 2 (Sheet 1 of 2)
OVERHAUL AND REPLACEMENT SCHEDULE
Inspection Inspection
Life Limit Time Interval Effectivity
Component (Flight Hours) (Flight Hours) (Flight Hours) Code
Engine:
Engine Mount Bolts (F.S. 106.0) 7,500 7,500 C
Main Landing Gear:
Top Cylinder Bolts (P/N 401-195) 1,400 C
Main Landing Gear Brace,
Pivot Shaft Assembly (P/N 43286-02) 1,500 C
Main Gear Retraction Arm (P/N 42042-02) 2,800 700 100 C
Link Bolt (P/N 400-209) 2,800 C
Link Assembly (P/N 85165-2 Rev B) 3,100 C
EFFECTIVITY:
A: 040-044, 053, 055, 057, 059
B: 048-052, 054, 056, 058, 060-999 C: 040-999 D: 045-047 5-10-00 PAGE 1 Mar 10/04
PIPER AIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCE MANUAL
A. Time Limits (continued)
CHART 2 (Sheet 2 of 2)
OVERHAUL AND REPLACEMENT SCHEDULE
Inspection Inspection
Life Limit Time Interval Effectivity
Component (Flight Hours) (Flight Hours) (Flight Hours) Code
Main Landing Gear: (continued)
Actuator (P/N 451-814) 10,000 * C
Hydraulic Cylinder (P/N 455-961) 10,000 * C
Hydraulic Power Pack (P/N 481-171) 10,000 * C
Hand Pump (P/N 481-771) 10,000 * C
Shuttle Valve (P/N 491-948) 10,000 * C
Unlock Actuator (P/N 551-968) 10,000 * C
* 10,000 Hours or Ten (10) Years, whichever comes first.
Nose Landing Gear:
Actuator (P/N 451-825) 10,000 * C
Shuttle Valve (P/N 491-949) 10,000 * C
* 10,000 Hours or Ten (10) Years, whichever comes first.
2.
Inspections Refer to 5-20-00 for Piper’s recommended Inspection Program.
3.
Life Limited Parts Marking and Disposition
14 CFR Part 43.10, Disposition of Life-Limited Aircraft Parts requires that proper procedures are followed when removing life limited parts with time and/or cycles remaining on them as well as the disposition of life limited parts with no time and/or cycles left. Life limited parts defined by Type Certificate (TC) are listed in paragraph 1, above. Other parts which are replaced or rebuilt at specified intervals are listed in Chart 2, above, and in 5-20-00 and 5-50-00.
A. Parts that are removed prior to accumulating their life limit, are to be marked with indelible ink or marker with the part number, serial number and accumulated life status as defined in 14 CFR Part 43.10 in a manner that does not affect part structural integrity, i.e. - no surface deformation such as vibration/etching allowed.
B. Parts that have accumulated the life limit shall be disposed of in accordance with the applicable FARs. Piper recommends life limited parts with no time and/or cycles remaining be completely destroyed.
EFFECTIVITY:
A: 040-044, 053, 055, 057, 059
B: 048-052, 054, 056, 058, 060-999
PAGE 2
C: 040-999
Mar 10/04 5-10-00
D: 045-047
PIPER AIRCRAFT
PA-42-720 (Advanced Trainer)
MAINTENANCE MANUAL
A. Scheduled Maintenance
1. General Purpose Description
The Piper Progressive Inspection program complieswith the F.A.A. Federal Aviation Regulations
Parts43, 91 and 135 for progressive inspections. The owner/operator is primarily responsible for
maintaining the airplane in an airworthy condition,includingcompliancewith all applicable
Airworthiness Directives and conformity with the requirements in FAR 91.169, 91.171 and 91.172.
The complete cycle inspection consists of two (2) 100 hour events, which provides for a complete aircraftinspectionin 200 aircraft flying hours. The complete inspection, events one and two must be complied within twelve (12) calendar months.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：夏延飛機維護手冊 Cheyenne IIIA PA-42-720 AMM 1(7)
