曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 
ABNORMAL OPERATIONS
OPERATING TECHNIQUES
 
THRUST CONSIDERATIONS
Consider the use of TOGA thrust, keeping in mind the following:
? For a FLEX takeoff, selecting the operating engine(s) to TOGA provides additional performance margin but is not a requirement of the reduced thrust takeoff certification. The application of TOGA will very quickly supply a large thrust increase but this comes with a significant increase in yawing moment and an increased pitch rate. The selection of TOGA restores thrust margins but it may be at the expense of increased workload in aircraft handling.
? For a derated takeoff �� , asymmetric TOGA thrust cannot be applied if the speed is below F in CONF 2 or 3 due to VMCA considerations.
? TOGA thrust is limited to 10 min.
PROCEDURE
INITIATION OF THE PROCEDURE
The PNF will closely monitor the aircraft's flight path. He will cancel any Master Warning/Caution and read the ECAM title displayed on the top line of the E/WD.
Procedures are initiated on PF command.
No action is taken (apart from cancelling audio warnings through the MASTER WARNING light) until:
? The appropriate flight path is established and,
? The aircraft is at least 400 ft above the runway, if a failure occurs during takeoff, approach or go-around.
A height of 400 ft is recommended because it is a good compromise between the necessary time for stabilization and the excessive delay in procedure initiation. In some emergency cases and provided the flight path is established, the PF may initiate the ECAM actions before 400 ft.
Once the PF has stabilized the flight path, the PNF confirms the failure. If it is necessary to delay the ECAM procedure, the PF should order "Standby", otherwise he should announce "ECAM actions".
Priority must be given to the control of aircraft trajectory, and acceleration phase should not be delayed for the purpose of applying the ENG FAIL ECAM procedure.
Should the PF require an action from the PNF during ECAM procedures, the order "STOP ECAM" should be used. When ready to resume ECAM procedure, the order "CONTINUE ECAM" should be used.
The procedure may be continued until "ENG MASTER OFF" (in case of engine failure without damage) or until AGENT 1 DISCH (in case of engine failure with damage) before acceleration.
Note: In case of ENG FIRE, fire drill remains high priority.
 
ABNORMAL OPERATIONS
OPERATING TECHNIQUES
 
ACCELERATION SEGMENT
At the engine-out acceleration altitude, push ALT to level off and allow the speed to increase.
If the aircraft is being flown manually, the PF should remember that, as airspeed increases, the rudder input needed to keep the beta target centred will reduce. Retract the flaps as normal. When the flap lever is at zero, the beta target reverts to the normal sideslip indication.
FINAL TAKE-OFF SEGMENT
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A330/A340 機組訓練手冊 FCTM Flight Crew Training Manual 2(26)