曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (i) Remove the screws (23) and the cover (24) from the terminal block 
R  (25). 
R  (j) Remove the nuts (26) and disconnect the electrical feeders from 
R  the terminal block (25).
 (2) Loosen the nut (31) of the pressure seal (32) on the wing above the
 pylon.
 (3) Remove the bolt (33) and the washer (34) from the clamp (37). 
R  (4) Remove the sealant from the bolt (35). 
R  (5) Remove the bolt (35) from the ground point (36). 
R  (6) Loosen the nut (45) of the pressure seal (46) at the wing and cargo
 compartment junction. 
R  (7) Disconnect the electrical feeders in the cargo compartment: 
R  (a) Remove and discard the lockwire (42) from the two screws (41). 
R  (b) Remove the screws (41) and the cover (43) from the terminal block 
R  (44). 
R  (c) Remove the nuts (40) and disconnect the electrical feeders from 
R  the terminal block (44). 
R  (8) Removal of the cable supports along the IDG feeder cables:
 (a) Cut and remove all the cable ties (1). 
R  (b) Remove all the bolts (3), the plate (4) and the spacers (5). 
R  (c) Remove all the bolts (7) and the nuts (8). 
R  (d) Remove all the nuts (9) and the bolts (10). 
R  (e) Disengage all the cable supports (2).

 

R R  IDG Feeders Figure 402/TASK 24-92-00-991-042-A15 (SHEET 1)
 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 414 Aug 01/05

 

R R  IDG Feeders Figure 402/TASK 24-92-00-991-042-A25 (SHEET 2)
 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 415 Aug 01/05

 

R R  IDG Feeders Figure 402/TASK 24-92-00-991-042-A35 (SHEET 3)
 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 416 Aug 01/05

 

R R  IDG Feeders Figure 402/TASK 24-92-00-991-042-A45 (SHEET 4)
 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 417 Aug 01/05

 

R R  IDG Feeders Figure 402/TASK 24-92-00-991-042-A55 (SHEET 5)
 1EFF : 1 1 1CES  ALL  1 111 24-92-00 Page 418 Aug 01/05

 

R  (9) Removal of the IDG feeder cables: 
R  CAUTION : BE CAREFUL NOT TO CAUSE DAMAGE TO THE IDG FEEDERS WHEN YOU_______ 
R  REMOVE/INSTALL THEM. 
R 
R  (a) Remove the IDG feeder cables from the wing, the pylon and the 
R  cargo compartment.

 

 TASK 24-92-00-400-002
 Installation of the IDG Feeders on the Wing and the Pylon
 1. Reason for the Job__________________
 Self Explanatory
 2. Job Set-up Information______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific No specific No specific  cable tieswarning noticeaccess platform 1.6 m (5 ft. 3 in.)
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R R R  Material No. 09-002 Material No. 19-010  USA MIL-S-8802 TYPE I CLASS B FUEL TANK SEALANTPOLYSULFID(NO LONGER AVAILABLE (Ref. 20-31-00)USA AMS 5687 LOCKWIRE STAINLESS STEEL ANNEALED 0.8MM DIA (Ref. 20-31-00) 

R 1EFF : ALL 1 24-92-00Page 420 1 1 Aug 01/05 1 1 1CES 1

 C. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
R R RR R R R R R  24-41-00-861-002 25-54-12-000-001 25-54-12-000-003 25-54-12-400-001 25-54-12-400-003 31-60-00-860-002 52-30-00-860-001 52-30-00-860-002 AWM 242201 AWM 242202 ESPM 204452 ESPM 204610 ESPM 204819 24-92-00-991-042-A  Energize the Aircraft Electrical Circuits from Engine 1(2)Removal of the FWD Cargo Compartment Partition FR34Removal of the Sidewall Panels in the FWD Cargo CompartmentInstallation of the FWD Cargo Compartment Partition FR34Installation of the Sidewall Panels in the FWD Cargo Compartment EIS Stop ProcedureOpen the FWD or AFT Cargo-Compartment Door with the Yellow Electric PumpClose the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump Fig. 402
 3. Job Set-up__________
 Subtask 24-92-00-860-084
 A. Aircraft Maintenance Configuration
 (1) On the center pedestal, on the panel 115VU, make sure that a warning notice is in position to tell persons not to start the engine.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ELECTRICAL POWER 電源2(146)