(b)
 Make sure that the fluid properties are in the limits.

 Subtask 29-00-00-611-053
 B. Replace the hydraulic fluid of the related hydraulic system , if the fluid properties are not in the limits (Ref. TASK 12-36-29-600-001), (Ref. TASK 12-36-29-600-002) or (Ref. TASK 12-36-29-600-003).

 TASK 29-00-00-280-006
 Check of the Green or Yellow Hydraulic System after Operation in a Possible Cavitation Condition of the Engine Pump
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-36-29-170-001 Flushing of the Green Hydraulic System of the Engine Driven Pump (EDP) 1030GK 12-36-29-170-002 Flushing of the Yellow Hydraulic System of the Engine
 Driven Pump (EDP) 3030GD 29-11-00-710-001 Operational Test of the Green Hydraulic System 29-11-43-610-040 Servicing of the Engine-Pump Case-Drain Filter
 (1084GM) 29-11-45-610-001 Servicing of the HP-Filter 1048GM 29-11-51-000-040 Removal of the Green Engine Pump (1030GK) 29-11-51-400-040 Installation of the Green Engine Pump (1030GK) 29-13-00-710-002 Operational Test of the Yellow Hydraulic System 29-13-43-610-040 Servicing of the Engine Pump Case-Drain Filter
 (3084GM) 29-13-45-610-001 Servicing of the HP-Filter (3048GM) 29-13-51-000-003 Removal of the Yellow Engine Pump (3030GD) 29-13-51-400-003 Installation of the Yellow Engine Pump (3030GD) 78-31-51-920-040 Replacement of the Hydraulic Control Unit Filter
 3. Job Set-up
__________
 NOTE : A cavitation condition of the engine pump is possible when the engine
____ pump operates with the engine pump fire valve closed (if you set the ENG 1 (2) FIRE pushbutton on the Eng/APU fire panel), or with the reservoir below the low level (ECAM indication).
 Subtask 29-00-00-860-078
 A. There is no special job set-up for this task.

 4. Procedure
_________

 Subtask 29-00-00-281-051
 A. Do a check of the engine pumps for a possible cavitation condition 
R R R R R  NOTE : Two procedures are included here to do a check if the engine pump____ has operated for more than 5 minutes in a possible cavitation condition. Each procedure is applicable for a different set of conditions. Only do the procedure that is applicable for the conditions you find.
R R R R  (1) Do the subsequent procedure if the engine pump has operated for more than 5 minutes: - With a closed engine pump fire valve - With the RSVR LO LVL warning on the upper ECAM DU and the fluid index below the minimum gaugeable level on the ECAM HYD system page.
R R  NOTE : There are no time limits if the engine pump is set to OFF (ENG____ 1 (2) PUMP FAULT/OFF pushbutton on panel 40VU) with the engine-pump fire valve open and the fluid level of the reservoir above the low level.
 (a) Replace the related engine pump (Ref. TASK 29-11-51-000-040) and (Ref. TASK 29-11-51-400-040) or (Ref. TASK 29-13-51-000-003) and (Ref. TASK 29-13-51-400-003).
 (b) Do the operational test of the related hydraulic system (Ref. TASK 29-11-00-710-001) or (Ref. TASK 29-13-00-710-002). 
R R R  1_  During the test, slowly move only one flight control surfaceat a time. Do this to prevent a pressure decrease to less than 2800 psi (193.0531 bar).
 (c) Do a check for particles in the filter bowl and the filter of the hydraulic control unit of the thrust reverser.
R R R  1_  If you find particles:- Replace the filter element (Ref. TASK 78-31-51-920-040). - Flush the related hydraulic system (Ref. TASK 12-36-29-170-001) or (Ref. TASK 12-36-29-170-002).

R R  (d) Do a check for particles in the case-drain filter bowl and the filter of the related engine pump.
R R R R  1_  If you find particles:- Replace the filter element (Ref. TASK 29-11-43-610-040) or (Ref. TASK 29-13-43-610-040). - Flush the related hydraulic system (Ref. TASK 12-36-29-170-001) or (Ref. TASK 12-36-29-170-002).
 (e) Do a check for particles in the HP filter bowl and the filter of the related system.
R R R R  1_  If you find particles:- Replace the filter element (Ref. TASK 29-11-45-610-001) or (Ref. TASK 29-13-45-610-001). - Flush the relevant hydraulic system (Ref. TASK 12-36-29-170-001) or (Ref. TASK 12-36-29-170-002).
 (f) Do the steps (b) thru (e) again, until all particles are removed.
R R R  (2) Do the subsequent procedure, if the engine pump has operated for more than 5 minutes: - With the RSVR LO LVL warning on the upper ECAM DU and the fluid index above the minimum gaugeable level on the ECAM HYD system page.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓1(88)