3. Job Set-up
__________
Subtask 30-11-00-941-069
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Before you do work on the Ice Protection system, put warning notices in position to tell persons not to: - operate the pneumatic system - operate the engines - operate the slats - operate the APU switch.
(3)
On panel 191DB, put a warning notice in position to tell persons not to pressurize the bleed air system.
4. Procedure
_________
Subtask 30-11-00-040-053
A. Deactivate the Two Anti-Ice Control Valves
R (1) Deactivate the two anti-ice control valves (Ref. TASK 30-11-00-040-001).
R (2) Make an entry in the aircraft technical log to tell the crew that the R wing anti-ice LT is deactivated.
5. Close-up
________
Subtask 30-11-00-942-067
A. Removal of Equipment
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the safety barriers.
(3)
Remove the warning notice(s).
(4)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
TASK 30-11-00-440-003
Reactivation of the Wing Anti Ice Fault LT
WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
-
THE FLIGHT CONTROLS
-
THE FLIGHT CONTROL SURFACES
-
THE LANDING GEAR AND THE RELATED DOORS
-COMPONENTS THAT MOVE.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
1. Reason for the Job
__________________
Refer to the MMEL TASK: 30-11-02
Wing Ice Protection
Wing Anti-Ice Pb Switch FAULT Light
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers No specific warning notice No specific warning notices
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
30-11-00-440-001 Reactivation of the Wing Anti Ice Control Valve 9DL(10DL) from the CLOSED position TSM CH 30
3. Job Set-up
__________
Subtask 30-11-00-941-070
A. Safety Precautions
(1)
Put the safety barriers in position.
(2)
Before you do work on the Ice Protection system, put warning notices in position to tell persons not to: - operate the pneumatic system - operate the engines - operate the slats - operate the APU switch.
(3)
On panel 191DB, put a warning notice in position to tell persons not to pressurize the bleed air system.
4. Procedure
_________
Subtask 30-11-00-440-051
A. Reactivate the Two Anti-Ice Control Valves
R (1) Reactivate the two anti-ice control valves (Ref. TASK 30-11-00-440-001).
(2) Do the applicable Trouble Shooting procedure for the wing anti-ice FAULT LT (Ref. TSM CH 30).
R (3) Make an entry in the aircraft technical log to tell the aircraft crew R that the wing anti-ice FAULT LT is reactivated.
5. Close-up
________
Subtask 30-11-00-942-068
A. Removal of Equipment
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the safety barriers.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ICE AND RAIN PROTECTION 防冰和排雨1(33)
