曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34 121VU HYDRAULIC/G HYD/PUMP ENG1/CTL 1701GK R35 121VU HYDRAULIC/G HYD/PUMP ENG1/MONG 1702GK R34
 1EFF : ALL 1 32-31-44Page 411 1 1 May 01/05 1 1 1CES 1 Subtask 32-31-44-941-052

 C. Safety Precautions
 (1) Make sure that the warning notices are in position to tell persons not to pressurize the Green hydraulic system: - on the panel 40VU in the cockpit, - on the ground service panel of the Green hydraulic system.
 Subtask 32-31-44-560-050
 D. Preparation of the Replacement Component
 (Ref. Fig. 401/TASK 32-31-44-991-001)

 (1) View D
 (a)
 Remove and discard the cotter pin (32) from the removed uplock assembly (8).

 (b)
 Remove the nut (31), the washer (30), the bolt (39) and remove the lever (29) from the uplock assembly (8).

 WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THE
_______
 SPECIAL MATERIAL.
 THIS MATERIAL IS DANGEROUS.

 (c)
 Apply SPECIAL MATERIALS (Material No. 05-002) to the splined shaft of the new uplock assembly (8), the bolt (39) and the washer (30).

 (d)
 Put the lever (29) in position on the splined shaft of the uplock assembly (8). Make sure that the master splines are aligned.

 (e)
 Install the bolt (39), the washer (30) and the nut (31).

 (f)
 Safety the nut (31) with a new cotter pin (32).

 (2)
 Make sure that the dimension "X" of the new component is the same of that retained from the removed component. (Ref. Fig. 402/TASK 32-31-44-991-002)

 (3)
 If necessary adjust to "Dimension X":

 (a)
 Cut and remove the lock wire from the eye end-lock nut.

 (b)
 Loosen the eye end-lock nut.

　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架4(171)