曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R 3. Job Set-up
__________
R Subtask 32-31-00-941-092
R A. Safety Precautions EIS Stop Procedure Removal of the Brace Tool from the Lockstay Actuator Installation of the Brace Tool on the Lockstay Actuator Installation of the Safety Devices on the Landing Gears Installation of the Safety Devices on the Landing Gear Doors Flight Configuration Precautions with Electrical Power Ground Configuration after Flight Configuration with Electrical Power Open the Main Gear Doors for Access Close the Main Gear Doors after Access Nose Gear Doors - Ground Doors Opening Nose Gear Doors - Ground Doors Closing
R (1) Make sure that the safety barriers are in position.
R (2) On the panel 400VU: R - make sure that the landing-gear control lever 6GA is in the DOWN R position R - make sure that a warning notice is in position to tell persons not R to operate the landing gear.
R (3) On the panel 110VU, make sure that the GRAVITY GEAR EXTN handle is R folded into the center console.
R (4) Make sure that a warning notice is adjacent to the MLG to tell R persons to keep clear.
 1EFF : ALL 1 32-31-00Page A535 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 32-31-00Page A536 1 1 Aug 01/05 1 1 1CES 1

R  Subtask 32-31-00-010-082 
R  B. Get Access 
R  (1) Open the MLG doors (Ref. TASK 32-12-00-010-001). 
R  (2) Open the NLG doors (Ref. TASK 32-22-00-010-001). 
R  (3) Make sure that the ground safety locks are installed on the landing 
R  gear and the landing gear doors (Ref. TASK 32-00-00-481-001) and 
R  (Ref. TASK 32-00-00-481-002). 
R  Subtask 32-31-00-869-115 
R  C. Flight Configuration Precautions 
R  (1) Do the flight configuration precautions (Ref. TASK 32-00-00-860-001). 
R  Subtask 32-31-00-865-118 
R  D. Make sure that this(these) circuit breaker(s) is(are) closed: 
R  -------------------------------------------------------------------------------
R  PANEL DESIGNATION IDENT. LOCATION 
R  -------------------------------------------------------------------------------
R  49VU L/G/LGCIU/SYS1/NORM 1GA C09 
R  121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 
R  121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34 
R  Subtask 32-31-00-860-109 
R  E. Aircraft Maintenance Configuration 
R  (1) Install the brace tool on the applicable MLG lockstay actuating 
R  cylinder (Ref. TASK 32-00-00-480-001). 
R  (2) Install a FALSE TARGET (98F32304000000) on: 
R  (a) The NLG extension proximity sensors 24GA and 25GA. 
R  (b) The MLG extension proximity sensors: 
R  - for the LH MLG 21GA and 23GA 
R  - for the RH MLG 20GA and 22GA.

 

R (3) Pressurize the Green hydraulic system using:
R - a ground hydraulic supply (Ref. TASK 29-10-00-863-001)
R or
R - the Yellow hydraulic system (through the PTU) (Ref. TASK 29-24-00-R 863-001).

R (4) Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-R 002).

R (5) Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only)
R (Ref. TASK 31-60-00-860-001).

R Subtask 32-31-00-081-055

R F. Removal of the Safety Devices

R (1) Remove the GROUND LOCK SLEEVE or the GROUNDLOCK SLEEVE from the
R applicable MLG lockstay actuator.

R 4. Procedure

_________ R Subtask 32-31-00-720-075 R A. Functional Test of the MLG Lockstay Actuating Cylinder with Brace Tool
R Installed R (1) Do this test: R -------------------------------------------------------------------------------
R ACTION RESULT R -------------------------------------------------------------------------------
R 1. On the panel 400VU:
R - move the landing-gear
R control-lever 6GA to the UP
R position.

R 2. On the panel 400VU:
R - move the landing-gear
R control-lever 6GA to the DOWN
R position.

R 3. Do the test procedure three
R times. This is to make sure that
R the actuator movement is the same
R each time.

On the aircraft:
-
monitor the movement of the actuator as it retracts, the movement must be free and smooth.

On the aircraft:

-
monitor the movement of the actuator as it extends, the movement must be free and smooth.

1EFF : ALL 1 32-31-00Page A537 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 32-31-00Page A538 1 1 Aug 01/05 1 1 1CES 1 1EFF : ALL 1 32-31-00Page A539 1 1 Aug 01/05 1 1 1CES 1

R  5. Close-up________ 
R  Subtask 32-31-00-860-110 
R  A. Aircraft Maintenance Configuration 
R  (1) Depressurize the Green hydraulic system (Ref. TASK 29-10-00-864-001). 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架4(96)