B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-224,
33-31-11-991-001 Fig. 401 R **ON A/C 106-149, 225-299, 301-399, 401-499,
33-31-11-991-001-A Fig. 401A **ON A/C ALL
3. Job Set-up
__________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-224,
Subtask 33-31-11-865-050
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2001VU LIGHT APU 2LJ D08
121VU APU/ECB/SPLY 1KD L41
121VU APU/APU/CTL 2KD L42
R **ON A/C 106-149, 225-299, 301-399, 401-499,
Subtask 33-31-11-865-050-A
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2001VU LIGHT APU 2LJ E08
121VU APU/ECB/SPLY 1KD L41
121VU APU/APU/CTL 2KD L42
**ON A/C ALL
Subtask 33-31-11-010-050
B. Get Access
(1)
Put the access platform in position below the APU compartment. WARNING : LOCK THE MECHANISM OF THE ACCESS DOOR 316AR WITH THE PIP
_______ PIN WHEN YOU OPEN THE ACCESS DOOR. THIS WILL PREVENT INJURY.
(2)
Open the APU access doors 315AL, 316AR.
(3)
Put the switch 11LJ at Zone 315 in the OFF position.
4. Procedure
_________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-224,
(Ref. Fig. 401/TASK 33-31-11-991-001) R **ON A/C 106-149, 225-299, 301-399, 401-499,
(Ref. Fig. 401A/TASK 33-31-11-991-001-A)
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-224,
Subtask 33-31-11-020-050
A. Removal of the Service Area Light and the Lamp
(1)
Removal of the Lamp
(a)
Remove the screws (12), the grid-screen (7), the lens (8) and the seal (9) from the housing (11).
(b)
Remove the lamp (10).
(2)
Removal of the Service Area Light
(a)
Remove the screws (6), the washers (5) and hold the service area light (4) to get access to the electrical connectors (1).
(b)
Remove the nuts (3), the washers (2) and the electrical connectors (1).
(c)
Put blanking caps on the disconnected electrical connectors.
(d)
Remove the service area light (4).
Service Area Light
Figure 401/TASK 33-31-11-991-001
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 33-31-11Page 404 1201-224, 1May 01/05 1 1 1CES 1
Service Area Light
Figure 401A/TASK 33-31-11-991-001-A
R 1EFF : 106-149, 225-299, 301-399, 401-499, 1 33-31-11Page 405 1 1 Aug 01/05 1 1 1CES 1R **ON A/C 106-149, 225-299, 301-399, 401-499,
Subtask 33-31-11-020-050-A
A. Removal of the Service Area Light
(1)
Remove the screws (4) with the washers (5) and hold the service area light (1) to get access to the electrical connectors (2) and (3).
(2)
Disconnect the electrical connectors (2) and (3).
(3)
Put blanking caps on the disconnected electrical connectors.
(4)
Remove the service area light (1).
R 1EFF : 106-149, 225-299, 301-399, 401-499, 1 33-31-11Page 406 1 1 Aug 01/05 1 1 1CES 1
R **ON A/C ALL
TASK 33-31-11-400-001
Installation of the Service Area Light 6LJ
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) R No specific 1 ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光1(104)
