4. Procedure
_________ Subtask 33-13-51-420-050
A. Installation of the Lighting Controller
(1)
Clean the component interface and/or the adjacent area.
(2)
Do an inspection of the component interface and/or the adjacent area.
(3)
Remove the blanking caps from the electrical connectors (4) and (5).
(4)
Put the lighting controller (1) in position opposite its housing (6). Hold it in this position.
(5)
Install the lighting controller (1) with the lockwashers (2) and the four screws(3).
Subtask 33-13-51-865-052
B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): FOR 6LF 3LF FOR 16LF 4LF FOR 30LF 5LF
Subtask 33-13-51-710-050
C. Do the operational test of the lighting controller (Ref. TASK 33-13-00-710-001)
5. Close-up
________ Subtask 33-13-51-410-050
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
FOR 6LF
Install the ceiling panel 211HC with an ALLEN wrench.
(3)
Close the access door 811.
FOR 16LF, 30LF
811
(4)
FOR 16LF, 30LF
Remove the access platform(s).
ANNUNCIATOR LIGHT TEST AND DIMMING - DESCRIPTION AND OPERATION
______________________________________________________________
1. General
_______ R R Bulbs supplied with 5VAC-400Hz are used for the lighting of the sun readable R lights in the cockpit. The current is delivered by the 115V/5V transformers. R Each light is parted in two sections ; each one has two 5V bulbs. R An annunciator light test switch permits illumination of all annunciators R and therefore check of all lights.
2. Component Location
__________________ R (Ref. Fig. 001, 002)
R -------------------------------------------------------------------------------R FIN I FUNCTIONAL DESIGNATION I PANELIZONEIACCESS I ATA R I I I I DOOR I REF. R -------------------------------------------------------------------------------R 1LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 2LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 3LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 4LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 5LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 6LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 7LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 8LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 9LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 10LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 11LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 12LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 18LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 19LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 20LP BOARD-ANN LT TEST & INTFC 70VU 126 822 33-14-33 R 31LP XFMR-ESS 211 33-14-51 R 33LP SW-INT LT/ANN LT 25VU 210 R 34LP P/BSW-LIGHT TEST 108VU 120 R 35LP XFMR-ESS 211 33-14-51 R 36LP XFMR-SYS 2 120VU 212 33-14-51 R 37LP XFRM-SYS 1 120VU 212 33-14-51
R
1EFF : ALL 1 33-14-00Page 1
1 1 May 01/05 1 1 1CES 1R Annunciator Light Test and Dimming - Component Location R Figure 001
1EFF : ALL 1 33-14-00Page 2 1 1 May 01/05 1 1 1CES 1
Annunciator Light Test and Dimming - Component Location
Figure 002
3. System Description__________________
R
R (Ref. Fig. 003)
R Miniature lamps (115 mA, 5VAC) are used for the lighting of the annunciator
R lights mounted on the panels and instruments in the cockpit.
R A relay (system) or internal contacts (case of ON-OFF position indication
R pushbutton switches) control illumination of each annunciator light. Four
R different busbars:
R - AC1 supply: 103XP
R - AC2 supply: 202XP
R - 115VAC STAT INV BUS: 901XP
R - Essential supply: 801XP
R supply the annunciator lights with 5VAC-400Hz through the transformers. In
R the case of emergency supply only busbar 901XP is serviceable.
R The system comprises:
A. Four Identical Transformers
Each one is supplied with 115V-400Hz.
Each one is connected to a different busbar.
They supply 5VAC-400Hz for the annunciator lights installed on the
overhead panel and on instrument panel and 6.3V voltage (full wave
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光1(43)
