曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 - push the line key adjacent to  - the TEST OK message comes into view. the TEST indication.
 5. Close-up
________
 A. Put the aircraft back to its initial configuration.
 (1) On the MCDU, push the line key adjacent to the RETURN indication R until the MCDU MENU comes into view.
R (2) Fully decrease the brightness of the MCDU screen (display off). R
 (3) De-energize the aircraft electrical circuits
 (Ref. AMM TASK 24-41-00-862-002).

 

 TASK 24-38-00-810-836
 Intermittent Warning because of an Internal Failure of the BCL1
 1. Possible Causes
_______________
 - BCL-1 (1PB1)

 - ELEC BAT1 pushbutton switch (7PB1)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 24-38-00-710-001 Operational Test of the Battery Charge Limiter (BCL), (without the CFDS) AMM 24-38-34-000-001 Removal of the Battery Charge Limiter (BCL) (1PB1, 1PB2) AMM 24-38-34-400-001 Installation of the Battery Charge Limiter (BCL) (1PB1, 1PB2)
 3. Fault Confirmation
__________________
 A. Test
 Not applicable, the failure is intermittent.

 4. Fault Isolation
_______________
 A. If the fault symptom is identified by the warning BCL1 FAULT without CFDS message:
 - release, and push again the ELEC BAT1 pushbutton switch (7PB1).
 (1) If the fault continues:
 - replace the BCL-1 (1PB1) (Ref. AMM TASK 24-38-34-000-001) and (Ref. AMM TASK 24-38-34-400-001).
 B. Do the Operational Test of the BCL (without CFDS) (Ref. AMM TASK 24-38-00-710-001).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞24-38-00∞∞∞∞∞∞∞∞∞∞Page 257
 Aug 01/00R
 CES  TASK 24-38-00-810-837

 Intermittent Warning because of an Internal Failure of the BCL2
 1. Possible Causes
_______________
 - BCL-2 (1PB2)

 - ELEC BAT2 pushbutton switch (7PB2)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 24-38-00-710-001 Operational Test of the Battery Charge Limiter (BCL), (without the CFDS) AMM 24-38-34-000-001 Removal of the Battery Charge Limiter (BCL) (1PB1, 1PB2) AMM 24-38-34-400-001 Installation of the Battery Charge Limiter (BCL) (1PB1, 1PB2)
 3. Fault Confirmation
__________________
 A. Test
 Not applicable, the failure is intermittent.

 4. Fault Isolation
_______________
 A. If the fault symptom is identified by the warning BCL2 FAULT without CFDS message:
 - release, and push again the ELEC BAT2 pushbutton switch (7PB2).
 (1) If the fault continues:
 - replace the BCL-2 (1PB2) (Ref. AMM TASK 24-38-34-000-001) and (Ref. AMM TASK 24-38-34-400-001).
 B. Do the Operational Test of the BCL (without CFDS) (Ref. AMM TASK 24-38-00-710-001).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞24-38-00∞∞∞∞∞∞∞∞∞∞Page 258
 Aug 01/00R
 CES  TASK 24-38-00-810-838

 Incorrect Discharge of the Battery 2
 1. Possible Causes
_______________
R - SEC-1 (1CE1) R - SEC-2 (1CE2) R - SEC-3 (1CE3)
 - PRESS SW-B HYD, FLT CTL (10CE1)

 - PRESS SW-G HYD, FLT CTL (10CE2)

 - PRESS SW-Y HYD, FLT CTL (10CE3)

 - ELAC-2 (2CE2)

 - BCL-2 (1PB2)

 - BAT-2 (2PB2)

 - PRESS SW-FLT CTL, G (1151GN)

 - PRESS SW-FLT CTL, B (2151GN)

 - PRESS SW-FLT CTL, Y (3151GN)

 - RELAY-ELAC2 EMER SPLY (48CE)

 - RELAY-ELAC1 BATT SPLY BREAKING (35CE)

 - RELAY-SEC1 BATT SPLY BREAKING

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific ammeter
 No specific warning notice(s)

 B. Referenced Information
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 電源 3(70)