C.  Procedure
 S 864-013
 (1)  Open the applicable circuit breakers that follow and attach a DO-NOT-CLOSE tag:
 (a)  
P18 Circuit Breaker Panel:
 1) HF-1 AC
 2) HF-1 DC

 (b)  
P6 Circuit Breaker Panel:
 1) HF-2 AC (if installed)
 2) HF-2 DC

 S 024-003
 (2)  Remove the HF transceiver (AMM 20-10-07/201).
 TASK 23-11-21-404-004
 3.  HF Transceiver Installation___________________________
 A.  General
 (1)  When you do the HF communication system test, make sure the airplane is not in or near any large metal structures. HF communications while the airplane is on the ground can be degraded by airplane orientation or by RF signal attenuation. If the transmitted and received voice is not satisfactory, move the airplane to a better position.
 B.  References
 (1)  
AMM 20-10-07/201, E/E Rack-Mounted Components

 (2)  
AMM 24-22-00/201 Electrical Power - Manual Control

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 23-11-21
 ALL  ú ú 05 Page 401 ú Nov 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 C.
D.
E.
A
737-300/400/500MAINTENANCE MANUAL
Access
 (1)  Location Zone 101 Control Cabin, left 102 Control Cabin, right 205 Electronics Compartment 218 Aft Cargo Compartment
Procedure
 S 424-005
 (1)  
Install the HF transceiver (AMM 20-10-07/201).

 S 864-012

 (2)  
Remove the DO-NOT-CLOSE tags and close the applicable circuit breakers that follow:

 (a)  
P18 Circuit Breaker Panel
 1) HF-1 AC
 2) HF-1 DC

 (b)  
P6 Circuit Breaker Panel
 1) HF-2 AC (if installed)
 2) HF-2 DC

Installation Test
 S 864-011
 (1)  Supply electrical power (AMM 24-22-00/201).
 S 864-009
 WARNING: DO NOT OPERATE THE HF COMMUNICATION SYSTEM WHILE FUEL IS PUT
_______ INTO THE AIRPLANE. INJURY TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 WARNING: MAKE SURE PERSONNEL STAY A MINIMUM OF 6 FEET AWAY FROM THE
_______ VERTICAL STABILIZER WHEN THE HF SYSTEM TRANSMITS. RF ENERGY FROM THE HF COMMUNICATION ANTENNA CAN CAUSE INJURIES TO PERSONNEL.
 (2)  Do these steps to prepare for an operational test of the applicable HF communication system (referred to as the HF system):
 (a)  
Connect the headphone to the captain's jack panel.

 (b)  
Connect the hand microphone to the captain's jack panel.

 (c)  
Set the captain's audio selector panel for the applicable HF system.

 (d)  
Do these steps at the applicable HF control panel:

 1)  Set the HF communication control panel mode select switch for the correct mode of operation for your location (USB/LSB/SSB or AM).
 2)  Set the frequency display to an approved test frequency.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 23-11-21
 ALL  ú ú 06 Page 402 ú Mar 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 714-008
 (3)  Do these steps to do an operational test of the applicable HF system:
 (a)  
Push and release a push-to-talk (PTT) switch.

 (b)  
Wait while the HF antenna coupler tunes the HF system to the set frequency.

 NOTE: A continuous or pulsed tone indicates that the coupler
____ is tuning to a new frequency. The coupler tune tone will sound no longer than 15 seconds. The average coupler tune tone is approximately 1 to 7 seconds.
 (c)  Speak with a tower radio operator. 1) Push and hold the PTT switch while you transmit. 2) Make sure the quality of the transmitted and received voice
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 通訊 COMMUNICATIONS(16)