23-27-00
ALL ú ú 03A Page 503 ú Mar 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(f)
Put in a DEP (departure) airport identification.
(g)
Put in a DES (destination) airport indentification.
(h)
Put in a fuel quantity in FOB.
(i)
Put in a fuel quantity in BD FUEL.
(j)
Make sure DENSITY is 6.7.
(k)
Push ENT.
(l)
Put in a FLT TIME.
(m)
Push the LSK adjacent to 1/2.
(n)
Put in OIL 1.
(o)
Put in OIL 2.
S 735-075
(3) Set the GMT.
(a)
Push the LSK adjacent to MENU until the PRE-FLIGHT FUNCTIONS show on the IDU.
(b)
Push the LSK adjacent to GMT.
(c)
Push the LSK adjacent to AUTO UPDATE.
(d)
Make sure the GMT is correct and continues to update.
S 735-076
(4) Do an OOOI sensor test.
(a)
Push the LSK adjacent to MENU until the ACARS MAIN MENU shows on the IDU.
(b)
Push the LSK adjacent to MISCELLANEOUS.
(c)
Push the LSK adjacent to ACARS STATUS.
(d)
Push the LSK adjacent to PROG ID/SENS STATE.
(e)
Make sure the A/C TYPE is correct.
(f)
Make sure the REG NO. is correct.
NOTE: The registration number is on a placard on the main
____
instrument panel.
(g)
Make sure the PROG ID is C08H.
(h)
Make sure the S/W date is 102894.
(i)
Close these doors:
1) Forward main door.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
23-27-00
ALL ú ú 03A Page 504 ú Mar 15/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
2) Aft main door.
3) Service doors.
(j)
Make sure ENT/SERV DOORS reads CLOSED.
(k)
Open the forward main door.
(l)
Make sure ENT/SERV DOORS reads OPEN.
(m)
Close the forward main door.
(n)
Make sure ENT/SERV DOORS reads CLOSED.
(o)
Repeat the above steps for the aft main door and the service door.
(p)
Close the cargo and EE doors.
(q)
Make sure CARGO DOORS reads CLOSED.
(r)
Open the cargo door.
(s)
Make sure CARGO DOORS reads OPEN.
(t)
Close the cargo door.
(u)
Make sure CARGO DOORS reads CLOSED.
(v)
Open the EE door.
(w)
Make sure the CARGO DOORS reads OPEN.
(x)
Disconnect the D752 connector on the switch for low oil pressure on the two engines (Fig. 501).
(y)
Ground pin 2 of each connector.
(z)
Close this circuit breaker: 1) On the load control center, P6:
a) THRUST REV CONT SYS (aa) Make sure ENGINES reads ON. (ab) Open this circuit breaker:
1) On the load control center, P6:
a) THRUST REV CONT SYS (ac) Remove the ground from pin 2 on the connectors. (ad) Make sure ENGINES reads OFF.
CAUTION:_______MAKE SURE IT IS SAFE TO RELEASE THE PARKING BRAKE. DAMAGE TO EQUIPMENT CAN OCCUR IF IT IS NOT SAFE.
(ae) Release the parking brake. (af) Make sure BRAKE reads RLS. (ag) Set the parking brake. (ah) Make sure the BRAKE reads SET. (ai) Open this circuit breaker:
1) On the load control center, P6:
a) LANDING GEAR AIR/GND RELAY & LTS (aj) Make sure AIR/GND reads AIR. (ak) Close this circuit breaker:
1) On the load control center, P6: a) LANDING GEAR AIR/GND RELAY & LTS (al) Make sure AIR/GND reads GND.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
23-27-00
ALL ú ú 03A Page 505 ú Mar 15/97
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 通訊 COMMUNICATIONS(41)
