34-28-61

 ú ú 02 Page 404 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 ADI INCLINOMETER - ADJUSTMENT/TEST
__________________________________
 1.  General_______
 A.  This procedure contains one task. The task is to adjust the inclinometer of an attitude director indicator (ADI).
 TASK 34-28-61-825-001
 2.  Adjustment - ADI Inclinometer_____________________________
 A.  References
 (1)  08-10-00/201, Leveling
 B.  Access
 (1)  Location Zones
 101/102 Flight Compartment

 C.  Procedure
 S 825-002
 (1)  Do the ADI inclinometer adjustment.
 (a)  
Remove the two button plugs from the front of the ADI.

 (b)  
Loosen the inclinometer adjustment screws a little bit.

 (c)  
If you install one ADI, adjust the inclinometer to agree with the inclinometer that was not removed.

 (d)  
If you install two ADIs, level the airplane and then adjust the two inclinometers to mid position (Ref 08-10-00/201).

 (e)  
Tighten the inclinometer adjustment screws.

 (f)  
Replace the two button plugs.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 34-28-61
 ú ú 02 Page 501 ú Mar 15/92

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 HSI - REMOVAL/INSTALLATION
__________________________
 1.  General_______
 A.  This procedure contains two tasks. The first task is for the removal of an horizontal situation indicator (HSI). The second task is for the installation of an HSI.
 B.  One HSI (N8) is installed on the captain's instrument panel P1. The other HSI (N9) is installed on the first officer's instrument panel P3.
 C.  Each HSI is installed through a hole in the flight instrument panel into a clamp. The clamp holds the HSI in its position. Two screws on the front of the HSI adjust the clamp.
 D.  Each HSI has an electrical cable attached to the rear of the unit through a connector.
 TASK 34-28-71-004-001
 2.  Remove the HSI______________
 A.  Access
 (1)  Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right

 B.  Procedure
 S 864-004
 (1)  
Set the COMPASS switch on the P1 or the P5 panel to the NORMAL position.

 S 864-002

 (2)  
Open these circuit breakers and attach DO-NOT-CLOSE tags:

 (a)  
P6-1 Load Control Center - Right
 1) CAPT COMPASS XFMR (ALTN)
 2) INSTR XFMR - 2

 (b)  
P18 Load Control Center - Left
 1) F/O CCOMPASS XFMR (ALTN)

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITHOUT EFIS ú

 34-28-71
 ú ú 03 Page 401 ú Mar 15/91

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 2) INSTRUMENT XFMR - 1

 S 024-003
 (3)  Do these steps to remove an HSI.
 (a) Loosen the higher right screw and the lower left screw.
 NOTE: Do not loosen the higher left screw or the lower
____ right screw. These screws hold the HSI clamp behind the instrument panel.
 (b)  
Push on the higher right screw and the lower left screw to loosen the clamp.

 CAUTION:_______CAREFULLY REMOVE THE HSI FROM THE INSTRUMENT PANEL. TOO MUCH FORCE CAN CAUSE DAMAGE TO THE ELECTRICAL CABLE AT THE REAR OF THE HSI.

 (c)  
Carefully pull the HSI away from the instrument panel until you can get at the electrical connector.

 (d)  
Disconnect the electrical connector from the HSI.

 TASK 34-28-71-404-012
 3.  Install the HSI_______________
 A. References
 (1)  AMM 24-22-00/201, Manual Control
 B. Access
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 導航 NAVIGATION 2(96)