(f)
Install lockwire on the nut.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-10
ALL ú ú C02 Page 403 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
(g)
Connect the CDP line to the CDP sensor nipple.
(h)
Tighten the nut to 270-300 pound-inches
(30-34 Newton meters).
(i)
Install lockwire on the nut.
S 424-019-C00
(3) Use four screws and washers to install the sensor.
(a) Tighten the screws to 32-35 pound-inches
(3.62-3.95 Newton meters).
S 414-012-C00
WARNING: OBEY THE INSTRUCTIONS IN THIS PROCEDURE WHEN YOU CLOSE THE
_______ THRUST REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(4)
Close the left thrust reverser half (AMM 78-31-00/201).
S 414-022-C00
(5)
Close the right fan cowl panel (AMM 71-11-02/201).
S 794-020-C00
(6)
Do an idle leak check (AMM 71-00-00/501).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-10
ALL ú ú C02 Page 404 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
VBV RESET SOLENOID - REMOVAL/INSTALLATION
_________________________________________
1. General_______
A. The VBV reset solenoid is found on the top aft side of the main engine
control (MEC).
TASK 73-21-11-004-003-C00
2. VBV Reset Solenoid Removal__________________________
A. References
(1)
AMM 24-22-00/201, Manual Control
(2)
AMM 71-11-02/201, Fan Cowl Panels
(3)
AMM 78-31-00/201, Thrust Reverser System
B. Access
(1)
Location Zones
506 Engine No. 1 - Aft side of MEC
606 Engine No. 2 - Aft side of MEC
(2)
Access Panels 5783L Engine No. 1 - Fan Duct Cowl and Thrust Reverser 5838R Engine No. 2 - Fan Duct Cowl and Thrust Reverser
C. Procedure
S 864-004-C00
(1) Remove the electrical power (AMM 24-22-00/201).
(a) Set the BAT switch on the Electrical Meters Battery and Galley Power Module (P5-13) to the OFF position and install a DO-NOT-OPERATE tag.
S 014-016-C00
(2) Open the right fan cowl panel (AMM 71-11-02/201).
S 014-017-C00
WARNING: OBEY THE INSTRUCTIONS IN THIS PROCEDURE WHEN YOU OPEN THE
_______ THRUST REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(3)
Open the left thrust reverser (AMM 78-31-00/201).
S 034-005-C00
(4)
Disconnect the electrical connector D3012 from the VBV reset solenoid.
S 024-006-C00
(5)
Remove the solenoid (Fig. 401).
(a)
Remove the two screws (and clamp, if it is installed) that attach the solenoid to the MEC.
(b)
Remove and discard the two O-rings.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-11
ALL ú ú C02 Page 401 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
VBV RESET
SOLENOID
SEE A (INSTALLED)
SEE B
FUEL SERVO (W1504) D3012
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 發動機燃油和控制(141)
