A. Method No. 412A: Turbine Wheel Assembly Balance Check and Re-balance ................... 448
B. Method No. 412B: Rotor Assembly Balance........................................................................449
C. Method No. 412C: General Balancing.................................................................................. 449
13. Repairing Electrical Components ................................................................................................ 456
A. Method No. 413A: Switch Assembly Repair ........................................................................ 456
B. Method No. 413B: Solenoid Assembly Repair (Receptacle Replacement) ......................... 458
C. Method No. 413C: Electrical Connector Repair (Pin Replacement) .................................... 459
D. Method No. 413D: Wiring Harness Assembly Repair .......................................................... 459
14. Remarking Parts ..........................................................................................................................464
A. Method No. 414A: Part Marking Guidelines and Methods...................................................464
15. Repairing Damaged/Oversized Diameters .................................................................................. 464
A. Method No. 415A: Sleeve With Same Material....................................................................464
B. Method No. 415B: Oversize Steel Liners ............................................................................. 467
C. Method No. 415C: Oversize Steel Bearing Liners (Plated).................................................. 467
16. Repairing Damaged/Oversize Threads ....................................................................................... 468
A. Method No. 416A: Damaged or Oversize Threads Corrected by Helicoil Inserts And Helicoil Twin-Serts.................................................................................................................468
B. Method No. 416B: Damaged Threads Corrected By Keensert. .......................................... 476
C. Method No. 416C: Damaged Threads Corrected By Threaded Shouldered Plug............... 476
17. Adjustment of Geometric Area.....................................................................................................478
A. Method No. 417A: Geometric Area Adjustment of Vanes.................................................... 478
SECTION V – ASSEMBLY
TABLE OF CONTENTS.......................................................................................................................... TC-1
1. General Assembly Practices........................................................................................................ 501
A. Protecting Unit During Assembly........................................................................................... 501
B. Corrosion Prevention Compound Removal........................................................................... 501
C. Verifying Cleanliness of Parts ............................................................................................... 501
D. Lubricating Splines and Gear Teeth...................................................................................... 501
E. Assembly Inspection, Guidelines, and Precautions .............................................................. 501
F. Lockwiring Techniques and Requirements ........................................................................... 501
G. Bearing and Gear Preparation, Handling, and Assembly Guidelines ................................... 501
H. Preparing Shafts for Seal and Packing Installation...............................................................501 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：標準施工手冊 STANDARD PRACTICES MANUAL 20-00-02/70-00-01(10)
